







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vinyl Fence in Lomita, CA: What It Costs and How Long It Takes
A vinyl fence installation in Lomita, CA typically runs $3,500 – $9,000 for a standard residential lot, and most jobs are finished in two to four working days once materials arrive. You’re getting a fence that won’t rot, won’t need paint, and holds its color through the marine layer that rolls through the Harbor Gateway most mornings. The exact number depends on linear footage, height, gate count, and how much old fencing has to come out first. Call (888) 345-8164 for a free on-site estimate and a written line-item quote.
How a Vinyl Fence Goes In, Step by Step

We don’t hand you a brochure and disappear. Here’s the actual sequence, so you know what to expect on day one versus day three.
Stage 1: On-site measure and layout (day 1, about 90 minutes)
We walk the property line with you, confirm where the fence lands relative to your setback, and mark post locations. You decide right then on height (most Lomita rear and side yards go 6 feet, with 4-foot front-yard sections common on the smaller bungalow lots), gate placement, and whether you want privacy panels or a picket-style top rail. If the old fence is going, we confirm what gets hauled away.
Stage 2: Demo and post holes (day 1 – 2, roughly 4 to 6 hours)
Old wood or chain link comes out first. Then we dig post holes to depth and set the posts in concrete. Vinyl posts are hollow, so we set them over a structural insert or fill them with concrete for wind and lean resistance. This is the stage that determines whether the fence stays plumb for the next twenty years. Quikrete fast-set mix is what we use for post setting because it cures predictably in our damp coastal air.
Stage 3: Concrete cure (24 to 48 hours, nothing for you to do)
The posts sit. We don’t rush this, and neither should anyone else. Setting rails and panels on uncured concrete is how fences develop that slow lean two summers later.
Stage 4: Rails, panels, and gate hang (day 3, 4 to 6 hours)
Panels snap or slide into the routed posts, top and bottom rails go on, and the gate gets hung with hinges and a latch. If you picked a self-closing gate hardware upgrade, it goes in now.
Stage 5: Walkthrough and cleanup (end of day 3 or 4)
We walk the run with you, check every post for plumb, test the gate swing, and haul off all packaging and old material. You sign off, and the workmanship is covered by our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Vinyl Options You’ll Actually Choose Between
Vinyl isn’t one product. What you pick here drives both the price and how the fence looks in year ten.
- Privacy panel versus semi-privacy. Full 6-foot privacy panels with tongue-and-groove pickets run toward the top of the range and give total screening. Semi-privacy (5-foot panels with a lattice or spaced top) costs less and lets the marine breeze through, which matters on the tight Lomita lots where air movement between houses is limited.
- Color and finish. White is the classic and still the most common. Tan, gray, and two-tone (dark posts, lighter panels) cost a little more but hide dust and salt film better than bright white. Ask about co-extruded color, where the color runs through the whole board rather than sitting on the surface as a cap.
- Post thickness. Standard 5-inch posts are fine for straight runs under 60 feet. Reinforced or 6-inch posts are worth the upgrade on longer runs, on windy corner lots, and anywhere a gate hinges.
- Gate hardware. Standard hinges and a thumb latch are included. Self-closing hinges, magnetic latches, and metal gate frames (for drive gates) are add-ons that extend the life of the piece that wears out first.
- Trim and caps. Post caps and top trim are cosmetic but protect the open post top from rain and debris. Cheap and worth it.
What a Vinyl Fence Costs in Lomita, CA

Most Lomita vinyl fence jobs land between $3,500 and $9,000. A short side-yard run on a 5,000 sq ft lot sits at the low end. A full perimeter with a drive gate on a corner lot pushes toward the top.
What moves the number:
- Linear footage. This is the biggest driver. A typical Lomita lot needs 100 – 180 feet of fence. Each additional 20 feet adds a few hundred dollars.
- Height and style. 6-foot privacy panels cost more per foot than 4-foot picket sections.
- Demo and haul-away. Removing an old rotted wood or chain link fence adds cost, more if the old posts are set in deep concrete that has to be broken out.
- Gates. A walk gate adds a set amount; a wider drive gate with a metal frame adds more.
- Site access and terrain. Sloped yards, tight side access, or a run that crosses a retaining wall or existing hardscape takes more labor.
A written estimate from us itemizes footage, style, gates, demo, and haul-away, so the number you see is the number you pay. No mid-job surprise line items. Upfront pricing, no surprises. Call (888) 345-8164 for your free estimate.
See the difference
Before
After
Before
After
Before
AfterWhat Lomita Homes Specifically Do to This Job
Lomita is a fully built-out Harbor Gateway city with almost no undeveloped land, so nearly every fence we install here replaces something old rather than fencing new ground. The housing stock is mostly 1920s – 1950s bungalows and early tract homes on 5,000 – 6,000 sq ft lots, plus 1960s – 70s stucco apartments along the major corridors. That means we’re usually pulling out a wood fence that’s been rotting at the base for a decade, and the old posts are set in concrete we have to dig out.
The bigger local reality is permitting. The City of Lomita runs its own building department with a small-city plan-check process layered over LA County’s coastal-area rules, and setbacks and height limits get negotiated lot by lot in a way they don’t in neighboring Torrance. Before we set a single post, we confirm whether your fence needs a permit and where the property line actually sits. The marine-layer fog and salt air here also drive corrosion on fasteners and hardware faster than homeowners expect, so we spec stainless or coated hardware on gates and any metal components.
For the wider project scope beyond the fence line, see our Fence Installation in Lomita page. And if the front of the house is getting attention too, homeowners often pair this with Driveway Repair & Replacement in Lomita or Asphalt Driveways & Resurfacing in Lomita while the equipment is out.
Serving Lomita, CA – Our Local Coverage Area
We serve Lomita and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Vinyl Fence in Lomita

Most Lomita vinyl fence jobs run two to four working days once materials arrive, with a 24 – 48 hour concrete cure built into the middle. Small side-yard runs can finish in a single day; a full perimeter with a drive gate takes longer. Call (888) 345-8164 to get a timeline for your specific lot.
It depends on height, location on the lot, and whether it’s a front-yard or corner lot, because Lomita runs its own plan-check process rather than defaulting to county rules. We confirm the permit requirement for your address before we start. Call (888) 345-8164 and we’ll walk you through it.
A standard residential job runs $3,500 – $9,000 in Lomita, depending on footage, height, gates, and demo. A short side-yard run sits near the low end; a full perimeter with a drive gate lands near the top. Call (888) 345-8164 for an exact written quote.
No. Our written estimate is itemized and fixed, so the number you see is the number you pay. If we uncover something genuinely unexpected, like a hidden retaining wall under the old fence line, we stop and talk to you before any extra work happens. Call (888) 345-8164 to schedule your free estimate.
All our fence work is covered by the 730-Day Done Right Promise: if it’s not done right, we make it right. The vinyl materials themselves also carry a manufacturer warranty, and we’ll spell out both in writing before we start. Call (888) 345-8164 to learn more.
Get Your Free Vinyl Fence Estimate in Lomita
We’ll come out to your Lomita property, measure the run, talk through style and gate options, and hand you a written line-item estimate at no cost. Our technicians have up to 12 years of experience, arrive in uniform, and are background-checked. Calls are answered by a live person, 24/7, so call (888) 345-8164 anytime to get on the schedule. Financing options include 0% for 18 months, and projects over $10,000 qualify for $1,000 off. Groundwork Construction Co. covers Lomita for vinyl fence work, and our Fence Installation service handles the full scope when you’re ready.
Written by the team at Groundwork Construction Co.












