







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Lomita, CA: What It Takes
Asphalt Driveways & Resurfacing in Lomita, CA usually runs $3,500 – $9,000 for a new asphalt driveway, and a resurfacing job (overlay on a sound base) lands well below that. A typical Lomita driveway goes down in one day of paving after a separate prep day, then cures for 24 – 48 hours before you park on it. Call (888) 345-8164 for a free on-site estimate.
From broken edge to sealed surface: how we run an asphalt job

Asphalt is a base-first material. Most of the money and most of the failure risk live in the layer nobody sees. Here’s the real sequence, stage by stage.
- Stage 1: tear-out and base inspection (day 1, roughly 3 – 5 hours). We strip the old asphalt down to the aggregate base. This is where the honest verdict gets made. If the base is dry, compacted, and holding its grade, you’re a resurfacing candidate. If it’s pumped, cracked through, or sitting on clay that’s heaved, you need full depth, and we tell you before the truck rolls. You decide resurface vs. replace on this day.
- Stage 2: grade, drainage, and edge (day 1, 3 – 4 hours). We re-cut the subgrade, set a 2% cross-slope so water sheds toward the street or a swale, and form the edges. Lomita’s marine layer means our morning damp air keeps the ground soft longer than inland jobs, so we compact in lifts and check density. You confirm the drainage direction and where the water should go – this is the decision that keeps puddles out of your garage.
- Stage 3: base prep and compaction (day 2, 2 – 4 hours). Four to six inches of compacted Class II base for a residential drive, done in lifts with a plate compactor and checked for grade. Skip this and the asphalt cracks within a season. We don’t skip it.
- Stage 4: hot-mix asphalt placement (day 2, 2 – 3 hours). Two inches of hot-mix asphalt, raked to grade, rolled with a drum and plate to a dense finish. The edges get hand-tamped. You should see a flat, closed surface with no tearing and no visible aggregate after rolling.
- Stage 5: cure, then seal (day 2, plus 24 – 48 hours). The asphalt needs to cool and set before you drive on it. We come back for a sealer coat after the mix has cured – not the same day, and not the next. Foot traffic usually OK after 24 hours, vehicle traffic after 48. You decide when to schedule the seal, and we put it in writing.
Whole job typically runs three to four working days on a standard Lomita drive. If we’re also tearing out a planter, reworking a curb, or tying into a garage slab, that ADU-and-slab work is where New Detached ADU in Lomita projects often overlap with driveway scope – the same excavation and grading crew gets reused.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll actually choose between
Asphalt isn’t one material. Here’s what we go over with you before a bid:
- Resurface vs. full replacement. A resurface (overlay) runs far less and buys you 8 – 12 years on a sound base. Full depth replaces the base and buys 20+ years. The honest rule: if the base is failing, an overlay is a bandage.
- Hot-mix vs. cold-patch for repairs. Hot-mix is the real deal, laid at 300°F+ and compacted tight. Cold-patch is a stopgap that sheds within a season. Small pothole repairs here are worth doing right.
- Asphalt thickness. Two inches is standard residential. Three inches handles heavier loads or a sloped drive where you’re parking a truck and trailer. The extra cost is real but modest.
- Base depth and material. Four inches of Class II base for light use, six for a heavily loaded drive. This is the biggest cost lever and the one that controls longevity.
- Sealer choice. Coal-tar and asphalt-based sealers are the standard; acrylic-modified sealers hold color longer but cost more. Sealing every 2 – 3 years protects against Lomita’s salt air and UV.
- Edge restraint. Concrete or steel edging holds the asphalt edge against Lomita’s soft coastal soil. Skip it and the edges crumble within a few seasons.
What Asphalt Driveways & Resurfacing costs in Lomita, CA

For a standard 2-car Lomita driveway (roughly 400 – 600 sq ft), full asphalt installation sits in the $3,500 – $9,000 range. Resurfacing over a sound base costs less than half of that. Sealing runs $250 – $700 and is the cheapest thing you can do to extend the life of the pavement.
Here’s what moves the number:
- Size. A 400 sq ft drive is at the low end; a 700 sq ft drive with a turnaround pushes toward $9,000.
- Existing condition. A failing base means full-depth removal and re-grading; that adds thousands over a resurface, but it’s the difference between 10 years and 25.
- Drainage and grade corrections. Re-cutting slope and adding a channel drain or swale adds $400 – $1,200 depending on run length.
- Access and demolition. A tight Lomita lot with no rear access, or a drive that has to be demoed by hand, costs more than an open-front lot where a skid steer can drive up.
- Add-ons. Widening, a concrete apron, a curb or gutter cut, and integrated edging all add to the line item. We break each out separately.
A written estimate should list: excavation and haul-off, base material and compaction, hot-mix asphalt type and thickness, edge restraint, seal coat (if included), and permit costs where required. What’s typically not included: landscape repair along the edges, irrigation relocation, and any concrete work outside the drive footprint. If the job is part of a full Driveway & Pavers in Lomita project with a patio or walkway, we price it as one scope, not two bids.
See the difference
Before
After
Before
After
Before
AfterWhat Lomita homes specifically do to an asphalt job
Lomita is a fully built-out Harbor Gateway city of roughly one square mile, incorporated in 1964 and ringed by Torrance. Almost no undeveloped land, so nearly every driveway job here is a tear-out on an existing infill lot, not a new build. That changes the work: we’re often pulling up 40 or 50 years of asphalt on a 5,000 – 6,000 sq ft lot where the drive was poured by the original 1920s – 1950s bungalow builder and never base-prepped right the first time. Marine layer and salt air do the rest – the damp morning fog keeps the ground soft, so a poorly compacted base pumps and cracks within a couple of seasons. We see this most on the small lots off the Pacific Coast Highway and Lomita Boulevard corridors, where a drive usually doubles as the only access for a garage or rear addition. Permits in Lomita run through the city’s own small-department plan check, and anything that changes the driveway’s footprint or drainage path needs a permit where a same-size resurface usually doesn’t – the city’s plan check is lot-by-lot, not a blanket rule, so we always confirm scope before bidding. If the driveway work is stepping toward a bigger project, our Driveway & Pavers service is the broader scope. We cover the full Lomita footprint, and much of this work pairs naturally with a Junior ADU & Interior Conversion in Lomita when a homeowner is reworking the back of a bungalow and wants the drive to match.
Serving Lomita, CA – Our Local Coverage Area
We serve Lomita and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Asphalt Driveways & Resurfacing in Lomita

A standard Lomita asphalt driveway takes three to four working days: one day tear-out and grade, one day base and paving, then 24 – 48 hours of cure before you park on it. Larger drives or jobs with heavy excavation push to a week. Call (888) 345-8164 for a scheduling window that fits your plans – estimates are free.
A same-size resurface usually does not require a permit, but any change to the driveway footprint, drainage path, or connection to the street typically does, and the City of Lomita’s plan check reviews it lot-by-lot. We confirm the permit scope before bidding so there are no surprises. Call (888) 345-8164 to talk through your job.
Resurfacing works only when the base underneath is sound, dry, and holding its grade. If the asphalt is pumped, cracked through to the base, or sitting on heaved soil, an overlay will fail within a season and you’ll pay twice. We inspect the base on day one and tell you straight. Call (888) 345-8164 to get your drive evaluated.
Asphalt driveway paving in Lomita runs $3,500 – $9,000, a full replacement runs $5,000 – $14,000, and a seal coat is $250 – $700. The gap between those numbers comes down to base condition and driveway size. Call (888) 345-8164 for an exact quote – estimates are free and we write them line by line.
Every asphalt driveway we install is covered by our 730-Day Done Right Promise – if the workmanship isn’t right, we come back and make it right, for two full years. The hot-mix and base work are backed in writing. Call (888) 345-8164 to review the warranty before you sign anything.
Get a free estimate for Asphalt Driveways & Resurfacing in Lomita
Call (888) 345-8164 to schedule a free on-site estimate for your Lomita driveway. We walk the lot, inspect the base, and hand you a written line-item quote with upfront pricing – the number you see is the number you pay. No pressure to book, no vague bids. Calls are answered by a live person 24/7, every day. We’ll tell you plainly whether you’re a resurface or a full replacement.
Written by the team at Groundwork Construction Co.












