







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vanities, Tile & Fixtures in Compton: What the Job Actually Involves
Vanities, tile & fixtures in Compton typically run $9,000 – $28,000 for a full hall or primary bath refresh, and most jobs take two to four weeks once materials are on site. That number covers a new vanity and top, floor and wall tile, and the fixtures that go with them – faucets, drains, a new toilet, lighting, and finish hardware. Call (888) 345-8164 and we’ll walk your actual bathroom before anyone quotes a figure.
How Vanities, Tile & Fixtures Get Installed, Stage by Stage

This work follows a fixed order. Swap the sequence and you’ll chip new tile setting a vanity, or re-open a wall you just closed. Here’s how it runs in a Compton bathroom.
Stage 1: Demolition and rough-in check (days 1 – 2)
We pull the old vanity, tear out tile and backer, and open the wall behind the vanity to look at what’s feeding it. In Compton’s older homes this is the moment of truth – original galvanized supply lines and cast-iron drains are common, and if they’re at the end of their life you want to know now, not after the tile is up. You’ll decide at this point whether to replace the shutoff valves and supply lines while the wall is open. That’s usually a few hundred dollars well spent.
Stage 2: Plumbing and electrical rough-in (day 3)
If the new vanity is wider or your fixtures move, the drain and supply lines get shifted and the vanity light and any GFCI outlets get wired to their new spots. This is also when the inspector sees the rough work if your job needs a permit. You’ll confirm fixture placement here – center the faucet on the sink, decide whether you want a second sconce, and lock in the vanity height.
Stage 3: Backer board, waterproofing, and tile layout (days 4 – 6)
We hang cement backer board, roll on a waterproof membrane in wet zones, and dry-lay the tile so you can see the layout before anything is stuck down. Grout line width, tile orientation, and where cuts land all get decided here. On a small Compton bathroom, layout is where a cheap tile looks expensive or a good tile looks sloppy.
Stage 4: Tile setting and grout (days 7 – 10)
Floor and wall tile go down with thin-set, cure overnight, then get grout and sealant. You pick grout color before this stage – it changes the whole look, and a light grout on a dark tile shows every bit of soap scum. Cure time matters: no shower use for 24 – 48 hours after grout.
Stage 5: Vanity set, fixtures, and punch list (days 11 – 14)
The vanity cabinet gets set and leveled, the top and sink go on, the faucet and drain connect, and we hang the mirror, light, towel bars, and toilet. Final walkthrough is with you, and anything on the punch list gets fixed before we call the job done. Most of that list is small – a door that swings a hair off, a caulk line that needs redoing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make
Here’s what gets picked, and the honest trade-off on each.
- Vanity cabinet – stock vs. semi-custom. Stock cabinets from a box store are the cheapest route and fine for a standard 30 – 48 inch opening. Semi-custom (KraftMaid and similar lines) buys you the exact width, door style, and drawer configuration your space wants. The gap is often $800 – $1,800 on the cabinet alone.
- Vanity top – cultured marble vs. quartz vs. granite. Cultured marble is the budget choice and holds up fine, but it scratches and can’t be repaired easily. Quartz and granite cost more but take a beating and last. Kohler and Cambria are worth asking about if you want a name you can look up.
- Floor tile – porcelain vs. ceramic vs. natural stone. Porcelain is denser and handles moisture better than ceramic; both are affordable. Natural stone looks great but needs sealing and is more slippery wet. For a hall bath in Compton, porcelain is the smart pick.
- Wall tile – full height vs. wainscot. Full-height tile costs more in material and labor but protects the whole wall from splash. A wainscot up to 48 inches is a common compromise and saves real money.
- Fixtures – brushed nickel, matte black, or polished chrome. Finish is taste, but budget matters: a full matching set runs from about $250 to $700 depending on brand and finish. Cheap fixtures are the first thing to fail – buy mid-grade.
What Vanities, Tile & Fixtures Cost in Compton, CA

Expect $9,000 – $28,000 for a complete vanities, tile & fixtures job in Compton. Where you land depends on a handful of things.
| Line item | Typical range |
|---|---|
| Bathroom vanity installation | $800 – $3,000 |
| Floor and wall tile | $2,500 – $9,000 |
| Fixtures (faucet, drain, toilet, light) | $600 – $2,000 |
| Plumbing/electrical rough-in (if moved) | $800 – $3,500 |
| Waterproofing, backer, prep | $600 – $1,800 |
| Permit and inspection (if required) | $300 – $900 |
What pushes a job to the top of that range: moving the drain or supply lines, upgrading to quartz or natural stone, full-height wall tile instead of wainscot, and discovering galvanized plumbing behind the wall that needs replacement. What keeps it near the bottom: keeping the layout, using porcelain floor tile, stock cabinetry, and no plumbing moves. A written estimate should spell out material grade, labor, and whether the permit is included. What it usually doesn’t cover: structural repair if we open a wall and find rot, or a surprise code correction on old wiring.
See the difference
Before
After
Before
After
Before
AfterWhat Compton’s Housing Stock Does to This Job
Most of Compton’s single-family homes are 1940s – 1960s stucco tract houses on small R-1 lots, and that build era shapes this work in specific ways. Original galvanized supply lines are common, and they rust from the inside and drop pressure over time – if we find them behind the vanity wall, that’s a real cost conversation. Knob-and-tube-era or early Romex wiring turns up too, and a new vanity light or GFCI outlet may mean correcting what’s behind the wall. You may want to check whether the bathroom electrical has a proper ground before we start.
Permitting in Compton runs through the city’s building department, and the plan check on a bathroom re-tile is usually lighter than on an addition or garage conversion, which is a very different and longer conversation in these older tracts. On a straightforward vanities, tile & fixtures job, the permit is often not required if you’re keeping the layout and not moving plumbing. If you’re part of a full Bathroom Remodeling in Compton project that touches plumbing or structure, the permit picture changes. Small lots and tight side-yard setbacks don’t affect an interior bath job, but they do affect staging – materials get stored tighter and we plan delivery accordingly. The dry, near-coastal climate means no freeze worry on exterior walls, but intense summer sun on a west-facing bathroom window is worth a thought when you pick window coverings.
Serving Compton, CA – Our Local Coverage Area
We serve Compton and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Vanities, Tile & Fixtures in Compton

Most jobs run two to four weeks from demo to walkthrough. The variable is material lead time – custom cabinets and quartz can add a week or two, while stock cabinets and porcelain tile are ready fast. Call (888) 345-8164 for a schedule that fits your job.
Often no, if you’re keeping the layout and only replacing fixtures and finishes. Moving a drain, adding an outlet, or changing the plumbing usually triggers one. We confirm the requirement before we start and pull the permit if it’s needed. Call (888) 345-8164 with your address and we’ll tell you.
Yes. A same-layout refresh is the most common version of this job and the most affordable. You get new tile, vanity, and fixtures in the same footprint. Moving things adds cost and complexity – ask us whether it’s worth it for your space.
Plan on $9,000 – $28,000 for a full bathroom. A partial – vanity and fixtures only, no floor tile – can come in under $9,000. Call (888) 345-8164 for an exact quote; estimates are free.
Every job we do is covered by the 730-Day Done Right Promise – if it’s not done right, we make it right. Our technicians have up to 12 years of experience, and calls are answered by a live person 24/7. Add that to the written workmanship warranty on your estimate.
Get a Free Vanities, Tile & Fixtures Estimate in Compton
We’ll come out, measure the bathroom, look at the plumbing and wiring behind the vanity, and hand you a written line-item estimate – no vague range, no surprise change orders. One of our team will walk you through material options and help you decide what’s worth the money. Compton homeowners often pair a bath refresh with exterior work; we also handle Tile Roofing in Compton and Specialty Roofing in Compton if the rest of the house needs attention. For the wider scope, see our Bathroom Remodeling service. We serve all of Compton, including ZIP codes 90220, 90222, and 90224. Call (888) 345-8164 – free estimates, 0% financing for 18 months, and $1,000 off projects over $10,000.
Written by the team at Groundwork Construction Co.












