







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wood Fence in Lynwood, CA: What It Costs and What’s Realistic
A new wood fence in Lynwood runs $3,500 to $9,000 for most residential lots, with the typical 90262 backyard landing between $4,800 and $6,200. A standard run of 100 to 150 linear feet goes up in two to three working days: posts set in concrete on day one, rails and pickets on day two, gates and cleanup on day three. Call (888) 345-8164 for a free on-site estimate and a written line-item quote.
How a Wood Fence Goes Up Here, Step by Step

Five stages, and you have a decision to make at each one. We don’t skip stages to save a day, because in Lynwood’s older small-lot housing, the ground under the fence line is rarely what the last person assumed.
Stage 1: Walk the line and mark utilities
We walk the property line with you, confirm where the fence actually goes (a survey or the existing pins, not a guess), and call 811 to mark buried utilities. In 1920s – 1960s Lynwood lots, that means gas, sewer laterals, irrigation, and sometimes old electrical runs to a detached garage. You decide the exact setback from the property line here, because that decision is hard to reverse once posts are in. Allow half a day.
Stage 2: Remove and prep
Old fence comes down, and this is where we find the real condition of the ground: rotted post bases, concrete footings from a fence two owners ago, tree roots, or a slab edge that’s shifted. We haul off the old material and set the new post line. On a typical Lynwood lot, demo and prep runs a day; if there’s a buried footing every eight feet, add a few hours with a breaker. You decide whether to keep any existing gates or hardware worth reusing.
Stage 3: Set posts and pour footings
Posts go in 24 to 36 inches deep, below our frost-free depth and into native soil, set in concrete and braced plumb. That concrete cures before anything loads the posts. You choose post spacing here (8-foot spans are standard; tighter spans cost more but stiffen the run) and post material, which we cover below. This is the stage that decides whether the fence is straight in year ten.
Stage 4: Rails, pickets, and gates
Rails go on, then pickets, then gates are hung and adjusted. Board-on-board, side-by-side, or shadowbox, and the height you picked in the estimate (6-foot is the most common, 4-foot where a sightline matters). Gate swing and latch height get set now, and we test them with you before the crew packs up. A full day for 120 feet with a gate.
Stage 5: Final walk and warranty paperwork
We walk the finished fence with you, check plumb and hardware, and leave the written warranty, which here is our 730-Day Done Right Promise. If a post heaves or a gate sags in that window, we come back and make it right. That final walk is 30 to 45 minutes and it’s where you sign off.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Wood Fence Options You’ll Actually Choose Between
Wood is the material, but wood fence covers a handful of real decisions. Here’s what changes the number and how each holds up in Lynwood’s wet-winter, hot-summer climate.
- Cedar vs. pressure-treated pine. Cedar resists rot and insects naturally and weathers to a warm gray; it costs more per linear foot. Pressure-treated pine is the workhorse: cheaper up front, but it wants a sealer within six months and a re-coat every couple of years or it checks and grays fast. For the long horizon, cedar wins on maintenance.
- Board-on-board vs. side-by-side. Board-on-board overlaps pickets for full privacy with no gaps and handles wind better; it uses more material, so it runs higher. Side-by-side is the budget pick and shows daylight between boards as it dries.
- Post material. Wood posts are fine set in concrete; steel posts cost more but won’t rot at the ground line, which is where wood fences fail first in a wet winter.
- Height and gates. 6-foot privacy height is standard; 4-foot is common along a front or a shared sightline. A walk gate is typical; a double drive gate adds hardware and framing cost.
- Finish. Stain or sealant now, or bare wood. Sealing sooner protects the investment; the trade-off is the added line on the quote.
What a Wood Fence Costs in Lynwood, CA

Most wood fence jobs in Lynwood land between $3,500 and $9,000. That spread comes down to five things, and each one moves the number in a predictable direction.
- Linear feet. The single biggest driver. 100 feet sits at the low end; 200 feet with multiple corners pushes toward the high end.
- Material grade. Pressure-treated pine is the floor; cedar board-on-board is the ceiling. The gap between them across a full run can be a couple thousand dollars.
- Demo and disposal. A fence down to bare ground is cheaper than one sitting on buried concrete footings that have to be broken out and hauled.
- Gates and hardware. Every gate adds framing, hinges, latch, and adjustment time.
- Site access and grade. A sloped or tight-alley lot means more labor per foot than a flat, open backyard off a north-south street near Long Beach Blvd.
A written estimate from us lists line items: linear feet by section, post count, gate count and hardware, demo and haul-off, and finish. What it won’t hide is permits, if your run needs one, because we pull those and pass inspection rather than leaving you to guess. Upfront pricing means the number you see is the number you pay; no change orders once the posts are set. For a broader look at how wood fits alongside other materials, see our fence installation service.
See the difference
Before
After
Before
After
Before
AfterWhat Lynwood Homes Specifically Do to a Wood Fence Job
Lynwood is a densely built city of one-story 1920s – 1960s stucco-over-wood-frame houses on 5,000 – 6,000 square-foot lots, and that housing stock shapes this job in ways a newer suburb wouldn’t. On lots this size, a fence line often runs right up against a detached garage, a converted-garage room, or an unpermitted addition from decades back, so we measure the actual buildable line, not the plat map. Plenty of these garages sit along the north-south streets off Long Beach Blvd, and when a homeowner is weighing a garage-to-ADU conversion, the fence line becomes part of a bigger site plan, which is why we treat the layout as part of the whole project rather than a standalone strip of pickets.
The climate matters too. Lynwood sits in the LA Basin with mild, wet winters and hot, dry summers, so a wood fence goes up any month, but winter rain is what exposes a fence built without proper post footings or a sealer. We see the same failure modes again and again: posts rotted at the ground line after a wet season, gates that sag once the soil dries and shrinks in summer, and pickets that check and cup under the sun. Set posts deep in concrete, pick the right material, and seal it, and a wood fence here holds up for the long run. When the fence work is part of a wider site change, homeowners often pair it with Paver Driveways in Lynwood or Concrete Driveways & Concrete Work in Lynwood to finish the yard in one pass. Everything we do in the 90262 ZIP and across Lynwood is covered by our 730-Day Done Right Promise.
Serving Lynwood, CA – Our Local Coverage Area
We serve Lynwood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Wood Fence in Lynwood

A standard residential wood fence in Lynwood takes two to three working days, from demo and prep through gates and final walk. Smaller runs of 60 to 80 feet can finish in a day and a half; larger lots with multiple corners, buried footings, or a drive gate stretch to four days. Call (888) 345-8164 and we’ll give you a day-count with your estimate.
It depends on height and location, and we confirm it against current city requirements before we build, not after. Fences along a property line versus a front or corner sightline often fall under different height rules, and some runs need a permit or an inspection while others don’t. We handle that scoping so you’re not the one calling the city. Call (888) 345-8164 with your lot details for a straight answer.
Usually yes, because a wood fence can be routed around a sewer lateral, irrigation line, or a garage wall rather than through it. The catch on older Lynwood lots is buried utilities and old concrete: we call 811 to mark lines and adjust post spacing to miss them, which costs nothing but a plan. If the fence line has to shift around a structure, we tell you before we quote, not mid-job.
Most wood fence projects in Lynwood run $3,500 to $9,000, with a typical backyard near the middle of that range. Linear footage, cedar versus pressure-treated pine, demo and disposal, and gate count are what move the price. Call (888) 345-8164 for an exact quote; estimates are free and written line by line.
Every wood fence we build is backed by our 730-Day Done Right Promise: if it isn’t done right, we make it right, for two full years after the crew leaves. That covers our workmanship, like posts that heave or gates that sag. Material wear from sun and rain is normal and why we recommend a sealer. Call (888) 345-8164 to schedule your free estimate.
Get a Free Wood Fence Estimate in Lynwood
If a wood fence is on your list this year, call (888) 345-8164 and we’ll set up a free on-site estimate. On that visit we measure the run, check the ground and utilities, walk you through cedar versus pressure-treated, and leave you a written line-item quote with upfront pricing and no surprises. Every job is covered by our 730-Day Done Right Promise. Part of a full Fence Installation in Lynwood project or just one run, it’s the same free estimate.
Written by the team at Groundwork Construction Co.












