







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Compton, CA: What It Costs and How Long It Takes
A chain link fence in Compton typically runs $3,500 – $9,000 for a full residential lot, and most single-yard jobs are finished in two to four working days once the layout is set. The number that lands inside that range depends on linear footage, height, gauge, gate count, and how tight the side-yard clearances are on your lot. Call (888) 345-8164 with your address and a rough footage count and we can narrow it down before anyone sets foot on the property.
How a Chain Link Fence Goes In: The Five Stages

We run this job the same way every time, because a chain link fence that sags, leans, or rattles after two Santa Ana wind seasons usually traces back to a skipped step in the ground work. Here’s the actual sequence.
Stage 1: Site visit and layout (day 1, 45 – 90 minutes)
We walk the property line with you, confirm exactly where the fence sits, and flag anything in the way: mature tree roots, a concrete mow strip, sprinkler lines, or an existing block wall you may want to build off instead of replace. On Compton’s tighter R-1 lots this is the stage where the conversation about shared fences with a neighbor actually happens. You decide the fence line and the height here, and nothing gets dug until you sign off.
Stage 2: Utility locate and permit check (day 1, same visit)
Before we auger a single hole we confirm where water, gas, and electrical lines run across the fence path. Old Compton tract homes sometimes have line runs that aren’t where you’d guess, and the utility locate takes a scheduled window, so it can pause the job a day. If your fence meets a height or setback threshold that requires a permit, we pull it and schedule the inspection to land after posts are set but before the mesh goes up. You don’t handle the paperwork; we do.
Stage 3: Demo and post setting (days 1 – 2, one to two days depending on removal)
If we’re replacing an existing fence, the tear-out comes first. Posts get set in concrete, plumb and at a consistent depth below grade, and the concrete needs roughly 24 hours to cure before tension goes on the mesh. This is the stage you’ll see the most activity. On a typical Compton lot with alley access, we set posts at the back and work forward so the trucks stay where they won’t block a neighbor’s driveway.
Stage 4: Rails, mesh, and gates (day 2 – 3)
Top rail, tension wire, mesh, and gate hardware go on after the concrete sets. Gate swing direction and latch height are your choice, and we’ll walk the gate with you before we tension the mesh so the swing clears your walkway. Rolling gates (not the remote kind you’re picturing on a garage door, but ground-rolling chain link gates for a driveway) get the track or carrier set at this stage.
Stage 5: Final walk and tension check (last day, 30 minutes)
We tension the mesh, check every post for plumb, and walk the perimeter with you. Anything that doesn’t sit right gets fixed before we leave, and anything that surfaces later is covered by the 730-Day Done Right Promise. That’s the full sequence. No surprises, no “we’ll come back Monday.”
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between on a Chain Link Fence
Chain link isn’t a single product. The choices below are the ones that actually change how the fence looks and holds up, and each one moves the price.
- Framework gauge: The pipe diameter and wall thickness on rails and posts. Lighter residential gauge works fine for a backyard run, but a front yard along a sidewalk or a fence built to keep dogs in needs heavier pipe, and heavier pipe costs more per linear foot. This is the single biggest driver of how long the fence survives wind and slope.
- Mesh gauge and coating: Standard-thickness galvanized mesh is the workhorse. Heavier mesh and vinyl-coated mesh cost more but resist rust at the ground line, which matters in Compton where a lot of fences sit right against concrete mow strips and irrigation always seems to end up on the fence path.
- Height: 4-foot chain link works for property delineation. Most homeowners choose 5-foot or 6-foot for backyard privacy and pet control. Each step up adds material and labor, and 6-foot is often the height where a permit conversation starts.
- Gates: Walk gates are standard on every job. Driveway gates, rolling gates, and double gates cost more because they need heavier frames and different hardware. Decide now whether you want one or two gates, because adding one later means redoing the post.
- Finish color: Galvanized (silver) is the default and the least expensive. Vinyl-coated black or green looks more finished and warms up against a stucco wall. If you’re pairing the fence with a front-yard upgrade, homeowners often pair this with Concrete Driveways & Concrete Work in Compton so the fence line and the new apron read as one project rather than two.
What a Chain Link Fence Costs in Compton, CA

Residential chain link work in Compton lands in the $3,500 – $9,000 range for a typical small-lot run. Five things push a job toward the low or high end:
- Linear footage and corner count: A straight 80-foot run with two corners costs less per foot than a zig-zag property line with four corners and a dip around a detached garage.
- Existing fence condition: Tear-out and haul-away of an old fence, posts, and concrete footings adds labor. Concrete-encased posts take longer to pull than soil-set posts.
- Ground conditions: Chain link is a post-and-concrete job, so rocky soil, tree roots, or a run that crosses an existing slab all add time and cost. Older Compton tract homes sometimes have buried footings from long-gone structures.
- Gauge and height: Heavier pipe and 6-foot height move the number up. Lighter residential gauge and 5-foot stays near the low end.
- Gates and permit scope: Each gate adds cost. If the fence height or setback triggers a permit, that adds the permit fee and the inspection coordination, and we pull it so the fence passes the first time.
A written estimate from us is line-itemed. You’ll see the footage, gauge, height, gate count, tear-out, and permit line (if applicable) individually, along with the 0% financing for 18 months and $1,000 off projects over $10,000. What’s typically not included: removing mature trees from the fence line and relocating utility services, both of which we’d quote separately once we’ve seen the property.
See the difference
Before
After
Before
After
Before
AfterWhat Compton Homes Specifically Do to a Chain Link Fence Job
The older tracts in Compton were built tight. Most single-family homes in the 90220, 90221, 90223, and 90224 ZIP codes are 1940s – 1960s stucco tract houses on small R-1 lots with narrow side yards, and a lot of them have a detached garage at the back of the property with an alley-facing driveway. That layout changes the fence job in ways you don’t see in newer subdivisions. Alley-load access is the big one: fencing along the back of the property has to be staged from the alley, which means the crew parks in the alley, and that means we coordinate with the neighbors before the truck shows up. On a side-yard run narrower than about four feet, we hand-carry posts and concrete to the back because a wheelbarrow doesn’t fit. And when a fence line runs up against an existing block wall, we usually set the posts just inside the wall rather than trying to replace it, so you don’t redraw a shared boundary that predates the current owners.
The climate helps. Compton’s near-coastal SoCal weather means no frost heave, so post depth is driven by wind and soil rather than freeze codes. But the intense summer sun and annual Santa Ana wind events do punish a sloppy install, which is why we don’t skip the concrete cure before tension, and why we set heavier pipe on the wind-facing run. If your property line is shared with a neighbor and you’re replacing a fence that’s also part of a larger boundary plan, that’s part of a full Fence Installation in Compton, and we’ll roll it in.
Serving Compton, CA – Our Local Coverage Area
We serve Compton and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Compton

Most single-yard chain link fence jobs in Compton take two to four working days, including tear-out if there’s an old fence to remove. Post-setting and concrete cure eat the first day or two, and tension and gate work happens after. A straight run with no tear-out can land on the shorter end. Call (888) 345-8164 for a real timeframe on your property.
It depends on height and where the fence sits, and the safest answer is that the code thresholds are specific and we need to check them against your lot. What we can tell you: many residential chain link fences at standard backyard heights don’t require a permit, but front-yard fences and taller runs often do. We handle the permit pull if one applies, and we schedule the inspection. Call (888) 345-8164 and we can confirm what your address requires.
Yes. The older Compton tracts are full of narrow side yards, and we install fences in runs as tight as three feet by hand-carrying materials and using smaller augers. We’ll tell you on the site visit which runs will need that treatment so the estimate is accurate. Call (888) 345-8164 to set the visit.
Expect $3,500 – $9,000 for a typical residential project, with the number driven by footage, height, gauge, gate count, and how much tear-out is involved. Heavier pipe, 6-foot height, and multiple gates push toward the high end; a simple lightweight run lands near the low end. Call (888) 345-8164 for a line-itemed quote, and we’ll walk anything the site visit reveals that changes the price. Estimates are free.
Every chain link fence we install is covered by the 730-Day Done Right Promise: if the workmanship isn’t right, we make it right. That covers post setting, tension, gate alignment, and the install itself, which is why we’re willing to put it in writing. Material defects fall under the manufacturer, but the install is ours. Call (888) 345-8164 to talk through it.
Get a Free Chain Link Fence Estimate in Compton
If you’re ready to price a chain link fence in Compton, call (888) 345-8164 and a live person answers, day or night. We’ll take your address and rough footage, set a time for the free on-site estimate, and bring a written line-item quote you can read without a decoder ring. The written number is the number you pay: upfront pricing, no surprises, backed by the 730-Day Done Right Promise. Our technicians have up to 12 years of experience, and homeowners in the Fence Installation silo get the same treatment whether the job is a bolt-in backyard run or a full boundary rebuild paired with Asphalt Driveways & Resurfacing in Compton. Call today.
Written by the team at Groundwork Construction Co.












