







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Compton: What to Expect
Concrete driveway installation in Compton runs $4,500 – $12,000 for most residential jobs, and a full replacement lands at $5,000 – $14,000. A typical single-car or two-car pour takes three to five working days from demolition to the day you can park on it, with the concrete itself needing two to three days of curing before you drive on it. Call (888) 345-8164 for a free on-site estimate.
How We Pour a Concrete Driveway in Compton, Stage by Stage

The sequence matters more than the concrete itself. Here’s the real order of work, what happens when, and what you’ll be deciding at each step.
Stage 1: Site evaluation and layout (day 1, about two hours). We walk the existing surface, measure the driveway, check the slope away from the house, and look at what’s underneath. Old Compton driveways often sit over compacted native soil, broken-up asphalt, or the stumps of the original 1940s-1960s garage aprons. At this stage you decide the driveway’s footprint and whether we’re expanding it (which can mean moving a fence line or a planting bed) or replacing it in place.
Stage 2: Demolition and haul-away (day 1 into day 2). We break out and remove the old slab or asphalt, load it out, and clear the subgrade. This is where surprises show up: old utility lines, tree roots, or a section of the old surface that was never properly drained. You’ll confirm the haul-away scope and any extra excavation before we continue.
Stage 3: Grading, base, and forms (day 2, most of the day). The crew grades to a slope that carries water away from the foundation, lays and compacts the base material, and sets wooden forms to the driveway’s shape. On Compton lots with tight side yards, form placement is deliberate work. At this point you sign off on depth, slope, and surface finish before any concrete is ordered.
Stage 4: The pour (day 3, typically a morning start). Concrete arrives, spreads, and gets screeded, floated, and finished. You’ll want to be around to confirm the finish and where the control joints go. Crews then wait for setup and finish the surface.
Stage 5: Curing and joint sealing (days 3 through 5). We keep foot traffic off for at least 24 hours and vehicle traffic off for two to three days. Control joints get sealed, cleanup happens, and we do the final walkthrough. That’s when you can sign off on the job and know the 730-Day Done Right Promise is in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Concrete Options You’ll Choose Between
Concrete isn’t one product. Here are the decisions that actually change how your Compton driveway looks and holds up.
- Standard broom finish – the roughened surface most driveways get. Best grip in rain, forgiving on a tight budget, and it hides minor imperfections. This is the default choice for most infill homes in Compton.
- Exposed aggregate – the concrete’s top layer gets washed to reveal the pebbles underneath. More visual interest, better traction, but it collects dirt and costs more per square foot.
- Stamped or patterned finish – concrete is stamped to mimic brick, stone, or pavers. You get the look of pavers at typically lower material cost, though the finish can chip over time and you’ll want a stronger seal schedule.
- Broom vs. saw-cut joints – saw-cut control joints are cleaner than hand-tooled joints and give more predictable crack control. Choose saw-cut if you care about the finished look.
- Concrete thickness – 4 inches is standard for a car driveway; go to 5 or 6 inches if a truck, RV, or heavy trailer parks on it. That extra inch adds cost but prevents cracking.
- Rebar vs. wire mesh – rebar is the stronger reinforcement for a driveway with soil movement underneath. Mesh works for lighter loads.
- Color and tint – integral color holds up better than surface stain. Standard gray is the most durable and least expensive option.
If you’ve already looked at a full Driveway & Pavers project and are weighing materials, we can put both a concrete and a paver option in the same written estimate. Brands like Quikrete mix and Oldcastle base materials come up often on these jobs, and we use paving brands like Techo-Bloc and Cambridge when a homeowner chooses pavers over concrete.
What Concrete Driveways & Concrete Work Costs in Compton, CA

Concrete driveway installation in Compton typically runs $4,500 – $12,000 for a standard residential pour. A full replacement, including removal of the old slab, costs $5,000 – $14,000. Driveway sealing, if you’re keeping a slab you already have, is a much smaller job at $250 – $700.
Here’s what moves a Compton job to the low or high end of that range:
- Square footage. A standard two-car driveway is around 400 – 600 sq ft. Every 100 sq ft adds roughly $500 – $1,100 depending on thickness and finish.
- Existing condition. If the old slab is easy to break out and haul, demolition is cheap. If it’s over root systems or buried utility lines, that adds time and cost.
- Site access. Tight lots in Compton can mean the concrete truck can’t get close. A pump truck adds a real line item.
- Finish grade. Broom finish is base cost. Exposed aggregate, stamped, or colored concrete adds per-square-foot cost.
- Permit scope. A driveway apron touching the sidewalk comes with city permit and inspection requirements. A straight replacement in the same footprint usually doesn’t.
Every written estimate we give lists concrete yardage, demolition scope, reinforcement, finish, and joint style line by line. What’s not included is anything underneath the existing slab we couldn’t see before we broke it out, and we tell you that up front rather than surprising you mid-job.
See the difference
Before
After
Before
After
Before
AfterWhy Compton Driveways Wear the Way They Do
Most single-family homes we work on in Compton were built between the 1940s and 1960s, with shallow slab foundations and detached garages, and a lot of their original concrete is past it. Concrete from that era often cracked because it was poured thin, had no reinforcement, or sat over soil that was never compacted to today’s standards. Add decades of Southern California’s intense summer sun and Santa Ana wind events, and you get cracking, spalling, and sections that heave at the joints.
The tight lots in the 90220, 90222, and 90223 ZIP codes change how a job gets done here specifically. Side-yard clearances are narrow, so the concrete truck may not back in, staging space is limited, and the crew has to pour in phases where a lot in Carson or Gardena would allow a single continuous pour. That’s the trade-off on Compton infill lots, and it’s why we measure access before we quote rather than after.
When a Compton driveway is part of a larger plan, homeowners often pair it with a Garage Conversion ADU in Compton to add usable square footage, or a New Detached ADU in Compton when the lot allows. If you want the fuller driveway story, including pavers and finishes, see Driveway & Pavers in Compton. For the wider service map, visit our Compton service-area page.
Questions We Get About Concrete Driveways & Concrete Work in Compton

How long does a concrete driveway take in Compton?
Most jobs take three to five working days from demolition to final cleanup, plus two to three days of curing before you park on it. Tight-access lots can stretch that by a day if we have to pour in phases or bring in a pump truck. Call (888) 345-8164 for a timeline based on your actual driveway.
Do I need a permit for a concrete driveway in Compton?
Usually not if you’re replacing the driveway in its existing footprint. You do need a permit when the driveway touches or alters the public sidewalk, curb, or street apron. We check the permit requirements for your specific address before quoting, and we pull permits where they’re required. Call (888) 345-8164 for your estimate.
Can you replace my driveway without moving utility lines?
In most Compton jobs, yes. Water, sewer, and gas lines are typically deeper than driveway grade, and we can pour over them without relocation. If a line runs too shallow or sits in the way, we say so at the site evaluation, not after demolition. Call (888) 345-8164 for a site visit.
What’s the difference between a concrete driveway and a paver driveway?
Concrete installs faster, costs less per square foot, and needs resealing roughly every two to three years in this climate. Pavers cost more, but individual units can be lifted and replaced if one cracks. If you’re comparing both, we’ll put both numbers in one written estimate so the choice is clear. Call (888) 345-8164 for details.
What warranty comes with a concrete driveway?
Every concrete driveway we pour is covered by the 730-Day Done Right Promise. If the workmanship fails, we come back and make it right. That covers our labor and installation, not damage from root intrusion, soil settling, or vehicles outside the driveway’s rated load. Call (888) 345-8164 to schedule your free estimate.
Serving Compton, CA – Our Local Coverage Area
We serve Compton and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Scheduling Your Compton Concrete Estimate
Call (888) 345-8164 to schedule a free on-site estimate for concrete driveways and concrete work in Compton. We measure the driveway, check access and drainage, and hand you a written, line-item quote with nothing hidden. You’ll know the yardage, the finish, the timeline, and the price before you commit. Financing at 0% for 18 months is available, and projects over $10,000 get $1,000 off.
Written by the team at Groundwork Construction Co.












