







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Compton, CA: What It Costs and What to Expect
Door installation in Compton, CA typically runs $850 to $3,200 per door, with most single exterior doors landing between $1,200 and $1,900 installed. A standard interior door swap is a same-day job; an exterior entry door with new framing, flashing and hardware takes one to two days. Call (888) 345-8164 for a free on-site estimate and we’ll give you a written, line-item number before anything gets ordered.
Compton’s older stucco tract homes are where most of our door work happens, and the framing behind these walls has been settling for decades. That’s usually what decides whether the job is a two-hour hang or a full opening rebuild.
How our door installation process runs, stage by stage

Stage 1: Measure and open-up inspection (day of estimate, 30 – 45 minutes). We measure the rough opening at multiple points, check for square and level, and pull back trim where needed to see what the framing and sill actually look like. On 1940s – 1960s stucco homes this is where we find the rotted sill plates or damaged king studs that change the scope. You decide at this stage: repair the opening properly, or hang on an existing frame with minimal disturbance.
Stage 2: Ordering and lead time (1 – 3 weeks typical). Stock doors can be ready in days. A made-to-order entry door with sidelites or a specific finish can run three to six weeks. You make the material, swing direction and hardware choices here, and nothing gets ordered until you sign off on the written quote.
Stage 3: Demo and prep (2 – 4 hours). We pull the old door and frame, cut back stucco or drywall as needed, remove the old flashing and inspect the sill. Any rot gets cut out and replaced with treated lumber. The opening gets squared and shimmed before anything new goes in.
Stage 4: Set, flash and seal (3 – 5 hours). New frame goes in plumb and level, the door gets hung, and we flash the sill and head properly. This is the part that decides whether you get water intrusion in five years. New weatherstripping, threshold and hardware go on before finish work starts. Seismic anchoring matters too, since Compton is in a higher-shaking zone and an entry door that pulls loose in a quake is a real liability.
Stage 5: Trim, finish and walkthrough (2 – 3 hours). Interior and exterior casing goes back on, caulk and paint touch-ups get done, and we walk the door with you to check the swing, the latch, the deadbolt alignment and the seal. Anything that doesn’t sit right, we adjust before we leave.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The door options you’ll actually choose between
- Steel entry doors – the security-first pick for Compton. They hold up to forced-entry attempts better than anything else and run $900 – $2,000 for a standard size. The trade-off is dents and rust if the finish gets scratched, so they need repainting eventually.
- Fiberglass entry doors – look like wood, resist dents and moisture, hold up well under the intense summer sun this part of LA County gets. $1,100 – $2,500 installed. Better long-term than steel here, but not quite as rugged against a hard kick.
- Solid-core wood doors – warm, heavy, and they dampen street noise better than hollow doors. $700 – $1,800. They need more upkeep and can swell with seasonal humidity swings.
- Hollow-core interior doors – the budget choice for bedrooms and closets, $250 – $600 installed. Light, cheap, and they do the job fine where security isn’t a factor.
- Hardware and locking systems – this is where Compton homeowners spend real thought. A Grade 1 deadbolt with a reinforced strike plate, or a keypad and rolling-code smart lock, runs $150 – $500 on top of the door. The smart locks that re-code their own rolling access code are popular here because they don’t leave a key under the mat for anyone to find.
- Sliding and patio doors – a separate project with its own quoting, worth handling alongside a bigger job rather than on its own.
Andersen and Pella both make entry-door lines worth the conversation here, and we quote both so you can compare real numbers side by side.
What door installation costs in Compton, CA

Interior door replacement in Compton runs $250 – $600 per door installed. Exterior entry doors land between $900 and $2,500 per door, and a full opening rebuild with new framing and flashing pushes a single entry install to $2,600 – $3,500. A whole-house interior door package (five to seven doors) usually comes in at $1,800 – $3,800.
Here’s what moves the number:
- Opening condition. Straight, square framing keeps you at the low end. Rotted sills or out-of-square walls on older Compton homes add $300 – $800 in labor and framing.
- Door size and spec. A standard 36-inch door is the cheapest. Oversized, arched or custom-swing doors add cost fast.
- Security hardware. A basic deadbolt to a Grade 1 lock with reinforced strikes and a smart lock is a $150 – $500 swing.
- Stucco repair. Cutting back and patching stucco around an exterior opening runs $200 – $600 depending on how much gets removed.
- Permits. Like-for-like swaps usually don’t need one. Structural changes to the opening do, and that’s a separate line on your quote.
Your written estimate covers the door, hardware, labor, flashing, sealing and trim. Paint and any interior drywall patching beyond the opening are spelled out separately so there are no surprises. The number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Compton homes specifically do to this door installation work
The dense post-war tract housing across the 90220, 90222 and 90224 ZIP codes shapes how almost every door install goes here. Most single-family homes in Compton were built between the 1940s and 1960s as single-story stucco on small R-1 lots. The framing is original, the sills have been taking Southern California sun and Santa Ana wind-driven rain for sixty-plus years, and a surprising number of entry openings are out of square by a half inch or more. When we pull a door near the Compton Creek corridor or down off Alondra, we plan for sill repair as the rule, not the exception.
Permitting works differently here too. Because these are small infill lots with tight side-yard setbacks, any change to an opening that touches structure gets flagged during plan check, and inspectors look closely at seismic anchoring on exterior doors. A like-for-like swap often slides through without a permit, but widening an opening or adding a sidelite means filing with the city. We pull the permits and pass the inspections, and we tell you upfront which jobs need one.
Security is why most people in Compton call us in the first place. A failed lock, a door that doesn’t close flush, or an old hollow-core entry door is a real exposure. Upgrading to a solid or steel slab with a Grade 1 deadbolt is the most common fix we do. If your project grows into a wider scope, it’s often part of a full Windows & Doors in Compton upgrade, and homeowners often pair this with Chain Link Fence in Compton work to secure the side yard at the same time.
Serving Compton, CA – Our Local Coverage Area
We serve Compton and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: Door Installation in Compton

An interior door takes two to four hours, and an exterior entry door takes one to two days once materials are on site. Made-to-order doors add one to three weeks of lead time before we can schedule the install. Call (888) 345-8164 for a timeline tied to your specific door.
Like-for-like door swaps usually don’t require a permit; structural changes to the opening do. Widening a doorway or changing a header means filing with the city and passing an inspection. We handle the permit and inspection process and we tell you upfront whether your job needs one.
Yes, in most cases we replace a door within the existing opening and leave the structure alone. If the framing is out of square or rotted, we repair the opening itself without touching plumbing or moving walls. We confirm this at the on-site measure.
Most security upgrades run $1,200 – $2,500 installed for a steel or solid-core entry door with a Grade 1 deadbolt and reinforced strikes. The door type and lock grade are the two biggest levers. Call (888) 345-8164 for an exact quote, and estimates are free.
Every door we install is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. That covers labor and workmanship on the install, and manufacturer warranties cover the door itself. We put both in writing before you sign.
If you’re also fencing the property, our Vinyl Fence in Compton work pairs well with an exterior door upgrade, and you can see the rest of what we do on our Windows & Doors service page. We serve homeowners throughout Compton and the surrounding area.
Get your free door installation estimate in Compton
Call (888) 345-8164 and a live person answers, day or night. We’ll schedule a free on-site estimate at your Compton home, measure the opening, talk through door and hardware options, and hand you a written, line-item quote with the total locked in. Nobody pressures you to sign on the spot. Background-checked, uniformed technicians do the work, and the 730-Day Done Right Promise backs it in writing.
Written by the team at Groundwork Construction Co.












