







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
How much does Door Installation in Lomita, CA cost?
Door installation in Lomita runs $650 to $2,400 per door for most exterior and interior jobs, with coastal-rated entry systems at the top of that range and simple interior swaps at the bottom. A standard pre-hung door gets set in a single day; a new opening cut into old stucco takes two to three. Call (888) 345-8164 and we’ll give you a written, line-item number before anyone touches a hammer.
We do this work on tight infill lots throughout Lomita, and the small size of the city shapes the job more than people expect.
Our door installation process, stage by stage

Here’s exactly what happens, and when you’ll be asked to make decisions.
Stage 1: Measure and scope (day 1, about 90 minutes)
We measure the rough opening, check the frame for plumb and square, and probe the surrounding stucco and wood for rot. On 1920s – 1950s bungalows, we find soft framing at the threshold more often than not. At this point you pick the door style and material, and we tell you honestly whether your existing opening accepts a standard size or needs custom sizing.
Stage 2: Written estimate and permit check (1 – 3 days)
You get a line-item quote: door, hardware, framing repairs, flashing, finish. If the door is a new opening, is a required egress door, or changes the building’s exterior envelope, we pull the permit through the City of Lomita’s building department. On a straight replacement in an existing opening, a permit usually isn’t required. You decide the grade of door and whether you’re adding sidelites or a wider frame.
Stage 3: Demo and prep (day 1 of on-site work, 2 – 4 hours)
We remove the old door and trim, cut back damaged stucco where needed, and replace rotted framing and any compromised sill. This is where hidden damage surfaces, and we photograph it before we repair it so there are no surprise change orders.
Stage 4: Setting and sealing (day 1 – 2, 3 – 5 hours)
The door goes in, gets shimmed and plumbed, and the flashing and sealant go on. Coastal marine layer and salt air drive moisture into every gap, so this step gets more attention in Lomita than it would inland. Hardware, lockset, and threshold go in last.
Stage 5: Finish and walkthrough (day 2 – 3, 2 – 4 hours)
Trim, casing, and paint or stain, then a final check of swing, latch, and weather seal. We walk the door with you and hand over the warranty paperwork. Most replacements finish in a single visit; new openings and structural work stretch to three days.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The door options you’ll choose between
Your choices drive both the price and how the door holds up against South Bay salt air.
- Fiberglass entry doors: the sensible choice for coastal Lomita. They resist moisture and rot, hold paint well, and come in wood-grain textures. Mid-range on cost, low on maintenance.
- Steel entry doors: strong and secure, good for a side or service door off a detached shop. They can corrode at the seams near salt air and need touch-ups, so we spec a coated finish.
- Solid wood doors: the warmest look and the highest maintenance. Beautiful on a restored bungalow, but they need sealing every couple of years in this climate.
- Interior doors: hollow-core for closets and low-traffic rooms, solid-core for bedrooms and anywhere you want sound control. Solid-core is worth the upgrade on a hall bath door.
- Hardware and finish: satin nickel and powder-coated finishes last longer near the coast than polished brass, which pits. We fit Baldwin or Schlage locksets where the budget allows.
We stock quality brands and won’t push you toward a door that won’t survive the marine layer.
What Door Installation costs in Lomita, CA

Expect $650 – $2,400 per door, all in.
| Line item | Typical range |
|---|---|
| Interior door replacement | $650 – $1,200 |
| Exterior entry door replacement | $1,100 – $2,400 |
| New opening (framing + stucco) | $1,800 – $4,000 |
| Rotted framing and sill repair | $300 – $900 |
Four things push a job toward the high end: a non-standard opening that needs custom sizing, rotted framing discovered during demo, a new opening that requires cutting stucco and structural framing, and a premium door or finish. A tight infill lot that limits access to a rear or side door can also add labor.
A written estimate from us covers the door, hardware, standard framing repair, flashing, sealant, and finish. It lists what isn’t included – major structural repair, painting beyond the door and casing, or replacing an adjacent rotted window.
See the difference
Before
After
Before
After
Before
AfterWhat Lomita homes do to this door job
Lomita is a small, fully built-out Harbor Gateway city of about one square mile, incorporated in 1964 and hemmed in by Torrance on nearly every side. There’s almost no undeveloped land, so door work here is remodel and reno on 1920s – 1950s bungalows and early tract homes on 5,000 – 6,000 sq ft lots – not new construction. The City of Lomita runs its own building department, and permits, setbacks, and envelope rules get negotiated lot by lot in ways they don’t in sprawling Torrance. Older homes mean we routinely find knob-and-tube wiring near an entry door and galvanized plumbing behind a bath wall, so we open the wall carefully and address what’s behind it.
Along Pacific Coast Highway and Lomita Boulevard, the marine layer and salt-laden air beat on exterior doors until the flashing fails and the sill rots. We over-build the weather seal here on purpose. Homeowners often pair a new back door with a fresh Chain Link Fence in Lomita or a Vinyl Fence in Lomita, and it’s all part of a full Windows & Doors in Lomita refresh.
Serving Lomita, CA – Our Local Coverage Area
We serve Lomita and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Door Installation in Lomita

A standard replacement takes one visit, usually three to five hours. New openings and structural work run two to three days because of framing, stucco patching, and finish. We schedule around your day and give you the timeline in writing.
A straight replacement in an existing opening usually doesn’t need one. A new opening, a required egress door, or a change to the exterior envelope usually does, and the City of Lomita’s building department reviews it. We pull the permits and handle the inspection so you don’t touch the paperwork.
In most cases, yes. A same-size replacement avoids both. Widening an opening or relocating a door means cutting framing, and a bath door near plumbing may need the wall opened. We tell you before work starts which scenario you’re in.
No on anything we can see at the estimate. If we open the wall and find rotted framing or old wiring, we photograph it and quote the fix before touching it – no surprise line items. The number you sign is the number you pay.
Our workmanship is covered by the 730-Day Done Right Promise – if it’s not right, we make it right. That’s one of the longest guarantees in the residential space, and it applies to every door we install.
Get a free door installation estimate in Lomita
Call (888) 345-8164 and we’ll set a free on-site estimate for door installation in Lomita. A live person answers around the clock, so you get a time, not a voicemail box. On the visit we measure, check the framing, and hand you a line-item quote – the number you see is the number you pay, backed by our 730-Day Done Right Promise. Estimates are free.
Written by the team at Groundwork Construction Co. of Long Beach.












