







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in Compton, CA: What It Involves and What It Costs
A tub-to-shower conversion in Compton typically runs $3,500 to $10,000 and takes three to seven working days, depending on whether the drain has to move and what the walls look like once the old tub comes out. The job means removing the tub and its surround, reworking the drain and valve, waterproofing the wet area, and setting a new shower base and walls. Call (888) 345-8164 and we’ll walk you through scope and rough numbers before anyone comes out.
How a Tub-to-Shower Conversion Actually Runs, Stage by Stage

Most conversions follow the same five stages. What changes from house to house is how much the walls surprise us once the tub is gone.
Day 1: Protection and demolition
We cover floors and paths, shut the water at the fixture stops, and pull the tub, surround, and valve trim. A standard tub comes out in two to three hours; cast iron takes longer and gets cut and carried out in sections. You decide here whether the old tub is being hauled away or staying with you. By end of day the drain and rough plumbing are exposed and we know whether the original layout holds.
Day 1 – 2: Rough-in and inspection
This is where the drain move gets settled. If the new shower pan lines up over the existing drain, this stage is short. If you want a linear drain, a curbless entry, or a bench where the tub drain used to sit, the drain gets relocated and the floor gets opened. A licensed plumber makes the change, and in Compton a permit inspection on the rough plumbing typically happens before anything gets closed up. You sign off on fixture location and valve height before we proceed.
Day 2 – 3: Backer, waterproofing, and pan
The old drywall or greenboard comes off, cement backer or a foam board system goes on, and the pan gets set and sloped. Waterproofing is the part nobody sees and the part that decides whether the job lasts. A roll-on membrane or a bonded sheet system goes over the backer and into the pan, and we flood-test the pan before tile.
Day 3 – 6: Tile, glass, and trim
Wall tile sets first, then the floor, then grout and sealant. Glass gets templated after tile is set, so a framed or semi-frameless enclosure usually adds three to five working days for fabrication. You pick tile and glass at the start; you confirm layout and niche placement before the first tile goes up.
Day 6 – 7: Fixtures, punch, and walkthrough
Valve trim, shower head, drain cover, and any grab bars go in. We run water, check slope and drainage, clean up, and walk the job with you. Anything on the punch list gets scheduled before we call it done. Every conversion is covered by our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
For a straightforward conversion, you’re really picking four things: the base, the walls, the glass, and how much you’re willing to open the floor.
- Acrylic or fiberglass pan and surround: the least expensive path, roughly $3,500 to $5,500 installed. Fast, low maintenance, and a solid choice in a rental or a second bath. Trade-off is limited size options and a plastic feel up close.
- Tile walls over a waterproofed backer, acrylic pan: the middle of the range, roughly $5,000 to $7,500. Tile in a 12×24 porcelain runs budget-friendly and reads as a real upgrade. Trade-off is grout that needs sealing.
- Fully tiled with a mud-set or foam pan: roughly $7,000 to $10,000 and up. This is where you get a curbless entry, a bench, and a linear drain. Best durability and the best look, but it’s the option that most often requires moving the drain.
- Glass: framed is the budget option; semi-frameless and frameless step up in price and lead time. Skip glass entirely with a curtain rod and you save real money, but you lose the open feel most people convert for.
- Grab bars and blocking: cheap to add now, expensive to add later. We put blocking in the walls whether or not you install bars today.
We work with Kohler fixtures where the budget allows, and porcelain tile from a range of suppliers. The right answer depends on how long you plan to stay and whether this is the only bath in the house.
What Tub-to-Shower Conversion Costs in Compton, CA

Most conversions in Compton land between $3,500 and $10,000. The low end is an acrylic pan and surround over the existing drain. The high end is a fully tiled, curbless shower with frameless glass and relocated plumbing.
What pushes a job toward the top of that range:
- Moving the drain or valve: relocating the drain for a linear or curbless setup opens the floor and adds plumbing and inspection time, often $800 to $1,800.
- What the wall conceals: older Compton homes sometimes reveal soft framing or galvanized supply lines once the surround is off. Replacing a valve and a section of supply line runs a few hundred dollars; real framing repair runs more.
- Tile and glass grade: porcelain versus natural stone, and framed versus frameless glass, is easily a $2,000 swing on the same footprint.
- Permit scope: a straight swap with no plumbing change is a lighter permit than a drain relocation.
- Bathroom size: a standard 60-inch alcove keeps costs down; a wider or oddly shaped opening means custom pan work.
A written estimate from us lists demo, plumbing, waterproofing, tile, fixtures, and glass line by line. It typically excludes structural repair if we find rot or failed framing, and it excludes any change you make after tile is ordered. Upfront pricing means the number you see is the number you pay for the scope we agreed on.
See the difference
Before
After
Before
After
Before
AfterWhat Compton Homes Specifically Do to This Job
Most of the housing we work on in Compton is 1940s to 1960s single-story stucco on small lots, and that build era changes the job in one specific way: the wall behind the tub surround is often the wall with the original plumbing in it. Galvanized supply lines and early-era wiring show up more often than not, and we plan for the possibility rather than pretending it won’t happen. The narrow lots and tight side-yard setbacks in the older tracts also mean materials get staged in a driveway or on the street, so we schedule deliveries around parking on the block. If a valve or drain needs replacement, that’s a permitted plumbing inspection, and we pull the permit and see it through.
Compton’s warm, dry climate works in our favor here: no freeze risk means less concern about pipe insulation in exterior walls, and the intense summer sun means we keep adhesive and grout out of direct heat while it cures. We cover the ZIP codes 90220, 90222, 90223, and 90224, and we know the difference between a house near the older core and one closer to the newer edges of town. If you’re also thinking about the rest of the property, homeowners often pair bathroom work with Metal Roofing in Compton or with Tile Roofing in Compton while the house is already torn up.
When a conversion turns into more than a conversion, or the rest of the bath needs the same attention, it’s worth looking at the full scope of Bathroom Remodeling in Compton so the whole room gets planned at once instead of in pieces.
Serving Compton, CA – Our Local Coverage Area
We serve Compton and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Tub-to-Shower Conversion in Compton

A standard conversion takes three to seven working days, with the longer end tied to tile and glass lead times. Most of that time is waterproofing, tile setting, and cure time, not demolition. Call (888) 345-8164 and we’ll give you a realistic timeline for your specific bathroom.
Yes, if the drain or supply plumbing moves, and often for the shower pan itself. A straight fixture swap with no plumbing change is a lighter permit, but the inspection on the rough plumbing is what protects you down the line. We pull the permit and handle the inspection as part of the job.
In most cases, yes. If the new shower pan lines up over the existing drain, the tub comes out, the pan gets set, and the drain stays where it is. That’s the fastest and least expensive path, and it’s the one we recommend unless you specifically want a curbless entry or a bench.
Most jobs run between $3,500 and $10,000, with the range driven by plumbing relocation, tile and glass grade, and what the walls reveal once the tub is out. Call (888) 345-8164 for a written, line-item estimate at no cost.
Every conversion is covered by our 730-Day Done Right Promise: if something isn’t done right, we make it right. That’s one of the longest workmanship guarantees in residential construction, and it’s in writing, not verbal.
Get a Free Tub-to-Shower Conversion Estimate in Compton
If you’re ready to replace a tub you never use with a shower you’ll actually want, call (888) 345-8164. We’ll ask a few questions about your bathroom, schedule a free on-site estimate, and hand you a written, line-item quote with the price fixed for the scope we agree on. You can reach a live person any time. We’re glad to cover Compton and the surrounding area, and the call costs nothing.
Written by the team at Groundwork Construction Co.












