







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Lomita, CA: What to Expect and What They Cost
A paver driveway in Lomita typically runs $7,000 – $18,000 and takes 3 – 5 working days from demo to final compaction. The job is excavation, a compacted base, edge restraint, pavers set on a sand bed, and polymeric joint sand. On a standard 5,000 – 6,000 sq ft infill lot off Lomita Boulevard, most drives land near the middle of that range. Call (888) 345-8164 for a free on-site estimate.
How we build a paver driveway, stage by stage

Pavers are only as good as what sits under them. On the older wood-frame homes around Lomita, the base is where a driveway lives or dies, so we don’t rush it.
Stage 1 – Site walk and layout (day 1, about 2 hours). We mark the drive edges, check the slope away from the garage, and locate the water main, gas line, and any irrigation. You decide the paver pattern and border color at this point, because it changes the order. If the drive ties into an existing hardscape or a wider project scope, we measure that junction now.
Stage 2 – Demo and excavation (day 1, 4 – 6 hours). A typical single drive is 400 – 600 sq ft. We break out old concrete or asphalt, haul it off, and dig to a depth that gives you 6 – 8 inches of compacted base on a residential drive and 8 – 10 where a heavier vehicle parks. That’s the number that matters on a lot where someone keeps a truck or a boat.
Stage 3 – Base prep and compaction (day 2). Crushed aggregate goes in lifts of 2 – 3 inches, each plate-compacted. This is the stage that gets skipped by cheap crews and it’s the one that keeps pavers from rutting after a wet winter. We check grade with a laser so water sheds toward the street, not the garage.
Stage 4 – Edge restraint and laying (days 3 – 4). A concrete or spike-and-plate edge locks the field in place, then the sand setting bed goes down screeded flat. Pavers lay in about a day on a standard drive. You confirm any last accent row placement before we lock the border.
Stage 5 – Joint sand and cleanup (day 5). Polymeric joint sand swept in, activated with a light mist, then a final compaction pass. We walk the drive with you, check the transitions at the apron and garage threshold, and leave the site swept.
The whole thing is usually done in a single visit across the week. If a permit is required for a new curb cut or a widened apron, plan-check adds time before we start. That’s a conversation we have on the first walkthrough, not after the concrete is out.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The paver options you’ll choose between
Most of the decision is made in an hour at the sample table. Here’s what actually changes the outcome.
- Concrete pavers (the default). Interlocking units in tumbled or straight-edge profiles. The best value per square foot, holds color well in salt air, and any damaged unit can be pulled and reset without tearing up the drive.
- Clay brick pavers. Warmer look and a longer color life, but higher material cost and slightly fussier install on tight lots. Suits the older bungalows on the small 1920s – 1950s lots where a period look fits.
- Permeable pavers. Open-graded joints with a gravel base system. Worth it where you want to limit runoff toward the street, and a real option on lots where drainage is tight. Costs more up front.
- Base and restraint grade. The unseen choice. Heavier base and a concrete edge cost more and outlast the lighter build every time.
- Pattern and border. Running bond, herringbone, and basketweave all work; herringbone is the strongest under turning tires. A contrasting border adds a modest bump in material and time.
Brand-wise, we work with manufacturers like Belgard and Boral for paver lines, and pull in Atlas materials where the job calls for them. You’re choosing a finish, not a catalog entry.
What Paver Driveways cost in Lomita, CA

Paver driveway installation in Lomita runs $7,000 – $18,000 for typical residential jobs. The number moves on five things:
- Square footage. A short 300 sq ft drive lands near the low end; a long pull to a rear garage or an oversized pad pushes high.
- Existing surface. Breaking out old concrete costs more than asphalt; clean dirt or gravel is cheapest to start from.
- Base depth and soil. Heavier loads need deeper base. Tight, poorly draining soil needs more aggregate and careful grade work.
- Material grade and pattern. Premium clay or permeable systems sit above the concrete paver baseline.
- Permit scope. A widened apron or new curb cut means plan check with the City of Lomita, adding time and fees.
A written estimate includes demo, haul-off, base, edge restraint, pavers, joint sand, and cleanup, with the line items priced so you can see what you’re paying for. It doesn’t usually include unforeseen utility relocation or a full drainage system – those get quoted separately if the site calls for them. We give you the number upfront, and the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Lomita homes specifically do to this job
Lomita is a fully built-out Harbor Gateway city, about a square mile, incorporated in 1964 and surrounded by Torrance. There’s essentially no undeveloped land, so a driveway project here is almost always a replacement or a rebuild on a tight lot, never part of a subdivision. The city’s own building department runs plan check, and on lots along the Pacific Coast Highway and Lomita Boulevard corridors the setback and height realities of a small city mean the details get negotiated lot by lot. When we’re covering Lomita, that means we check the apron and curb-cut rules before the first shovel goes in. The housing stock is mostly 1920s – 1950s bungalows on 5,000 – 6,000 sq ft lots, and the failure we see most is old concrete that has cracked or settled after decades of marine-layer damp and salt air working on it. That salt-laden air also eats at fasteners and flashing, so we spec corrosion-resistant hardware on every build. If your driveway is part of a bigger project, homeowners often pair this with Garage Conversion ADU in Lomita work, or with ADU Design & Permitting in Lomita when a new drive serves a rear unit. Our Driveway & Pavers service covers the full scope.
Serving Lomita, CA – Our Local Coverage Area
We serve Lomita and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Paver Driveways in Lomita

Most paver driveways in Lomita are done in 3 – 5 working days from demo to final compaction. A standard single drive is often finished in a single visit across the week. Permit plan check, if required, adds time before we start. Call (888) 345-8164 for a timeline on your lot.
A replacement within the existing footprint often doesn’t, but a widened apron, new curb cut, or grade change can trigger City of Lomita plan check. We check your specific scope against the city’s requirements on the estimate walkthrough and tell you plainly whether a permit is needed. Call (888) 345-8164 to schedule the walkthrough.
No, we don’t recommend it, and we won’t do it. Setting pavers over cracked or settled concrete traps water, voids the value of the pavers, and adds height at the garage threshold. We break out the old surface and rebuild the base correctly. Call (888) 345-8164 to talk through your existing driveway.
Expect a range of $7,000 – $18,000 for a typical residential paver driveway in Lomita, which works out roughly in line with the size, base depth, and material you choose. The variables are square footage, old surface removal, soil drainage, and pattern or material grade. Call (888) 345-8164 for an exact line-item quote – estimates are free.
Every paver driveway we build is backed by our 730-Day Done Right Promise – if it’s not done right, we make it right. That covers our workmanship for two full years, and the pavers themselves carry their manufacturer warranty. Call (888) 345-8164 with any questions on coverage.
Get a free paver driveway estimate in Lomita
Call (888) 345-8164 for a free on-site estimate on paver driveways in Lomita. A live person answers, day or night. We’ll walk the drive, measure it, check the base conditions and any permit questions with the city, and hand you a written line-item quote. You see the full scope and the price, and you decide from there. Technicians are background-checked and arrive in uniform. Estimates are free, and the price you’re quoted is the price you pay.
Written by the team at Groundwork Construction Co.












