







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Impact Windows & Doors in Lomita, CA: What the Job Actually Involves
Impact window installation in Lomita typically runs $8,000 – $25,000 for a whole-house package, and most homes are measured in week one, installed across two to four days, and final-inspected within a few weeks of order. If your house sits near the Pacific Coast Highway corridor or off Lomita Boulevard and still carries 1960s single-pane aluminum sliders, the change in noise, heat, and security is immediate. Call (888) 345-8164 for a free on-site estimate.
How We Run an Impact Windows & Doors Project, Stage by Stage

An impact window job is mostly sequencing. The windows themselves go in fast; everything around them is where projects either sail or stall. Here’s the order we work in.
Stage 1 – In-home measure and product selection (day 1, about 90 minutes). We measure every opening, check the existing frames for rot, and photograph the stucco returns. You decide the frame material (vinyl, fiberglass, or aluminum) and the glass package at this visit, because lead time depends on it. Impact-rated units in custom sizes often run six to ten weeks from order.
Stage 2 – Permit and plan check. The City of Lomita’s own building department handles the window permit, and on a small-city plan-check desk that means a real conversation, not a rubber stamp. We submit the product approval paperwork, the opening schedule, and the installation detail, and we pull the permit. You don’t touch this part.
Stage 3 – Prep and demo (day 1 of install). Furniture gets pulled back, floors get covered, and the old units come out one at a time rather than the whole elevation at once, so the house stays closed up overnight. On 1920s – 1950s wood-frame bungalows this is where we find the surprises: rotted sill plates, old termite damage under a slider, or a header that wasn’t framed for the span. We stop, show you, and price the fix before we continue.
Stage 4 – Setting, flashing, and interior trim (days 2 – 3). Each unit is set plumb and shimmed, then flashed and sealed at the exterior. With salt air and morning marine layer, the flashing detail is what decides whether you’re re-caulking in three years or fifteen. Interior trim and casing go back the same day.
Stage 5 – Stucco patch, final inspection, walkthrough. Exterior stucco patching and paint touch-up follow the last window, then the city inspects. We walk the job with you, open and close every unit, and hand over the warranty paperwork. Most homes in Lomita close out in one to two weeks from the first day of install.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between, and What Each One Costs You
Three or four decisions carry almost all the weight on this job. Here’s the honest trade-off on each.
- Vinyl frames: The value pick. No corrosion in salt air, no painting, and the lowest price point in the range. The trade-off is color: you’re limited to white and a few beige tones, and they can’t be painted later without looking like it.
- Fiberglass frames: Stronger, paintable, and they hold up better on wider openings where vinyl wants reinforcement. Costs more per opening, and not every manufacturer stocks the size quickly.
- Aluminum frames: Slim sightlines, popular on the mid-century homes along the corridors, and they can be finished to match a darker palette. Watch the thermal break, or the frame sweats in the marine layer.
- Glass package: This is where the real money moves. Laminated impact glass with a low-E coating is the standard for this job; the upgrade is a heavier interlayer or a different tint. Ask what the visible light transmission number is, because a dark tint changes how the room feels in winter.
- PTG and similar impact-rated lines come up often because they carry the product approval documentation California inspectors want to see. Atlas and Tamko components turn up in the door and flashing assemblies as well.
- Configuration: Fixed picture windows cost less than sliders or casements of the same size. If you have a wall of glass facing a neighbor’s roofline, a fixed unit with one operable panel gets you the light for less.
What Impact Windows & Doors Cost in Lomita, CA

Whole-house impact window installation in Lomita lands between $8,000 and $25,000. A handful of openings on a small bungalow sits near the bottom; a full-house package on a larger home with doors and custom sizes pushes toward the top.
Five things move that number:
- Opening count and size. Pricing is per opening, and a wide slider costs several times a small awning window.
- Frame material. Vinyl to fiberglass to aluminum steps up in cost, and aluminum with a thermal break is the top of that ladder.
- Existing condition. Rot, missing headers, or a 1950s opening that was never squared properly adds carpentry time before the window goes in.
- Permit and plan-check scope. Lomita’s own building department reviews the submittal; a straightforward replacement is simpler than a job that changes opening sizes, which triggers structural review.
- Access and staging. Tight infill lots with a narrow driveway make material handling slower. It’s a cost, not a dealbreaker.
A written estimate from us is line-item: each opening by size, frame material, glass package, trim, flashing, stucco patch, permit, and haul-away. What’s often left out of other bids is stucco repair, interior casing, and disposal. Ask, in writing. The number you see is the number you pay, and every job carries the 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat Lomita Homes Specifically Do to This Job
Lomita is about one square mile, fully built out, and surrounded by Torrance, so there’s essentially no new construction here. What we work on is the 1920s – 1950s bungalows and early tract homes on 5,000 – 6,000 sq ft lots, plus the 1960s – 70s stucco apartments along the major corridors. That housing stock shapes the window job in ways a newer city’s doesn’t: wood-frame openings that have settled, single-pane aluminum sliders that no longer latch, and stucco that has already cracked from decades of damp morning fog and salt-laden air. Corroded fasteners and flashing are routine finds.
Permitting runs through the City of Lomita’s own building department, not a county counter, and it layers on top of LA County’s coastal-area rules in pockets. On the tight lots off Lomita Boulevard and near Pacific Coast Highway, second-story additions and ADUs routinely brush the city’s height and rear-setback limits, which means window placement and shading get worked out against a specific adjacent roofline before plans ever go to plan check. If you’re changing opening sizes as part of a larger remodel, that work belongs in the wider scope, so start with Windows & Doors in Lomita and we’ll sequence it correctly. If you’re also replacing a gate at the driveway, homeowners often pair this with Aluminum Fence in Lomita or Iron Fence in Lomita while the crew is on site.
We cover all of Lomita and the neighboring South Bay cities, and our Windows & Doors service handles the full scope from a single slider to a whole-house package.
Serving Lomita, CA – Our Local Coverage Area
We serve Lomita and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Impact Windows & Doors in Lomita

Most Lomita homes take two to four days on site, with six to ten weeks of lead time before that for order and permitting. Small jobs with stock sizes can move faster.
Yes. The City of Lomita’s building department requires a permit for window replacement, and the inspection is part of the job. We pull it and handle the submittal.
In most cases, yes. A same-size replacement reuses the existing opening and framing. If the old unit was installed out of square or the framing has rot, we price the carpentry repair before proceeding.
Whole-house installation runs $8,000 – $25,000, and single openings start far lower. Frame material, glass package, and how many openings you’re doing drive the total. Call (888) 345-8164 for an exact quote, and the estimate is free.
Every installation is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. Manufacturer coverage on the glass and frames comes separately.
Get a Free Impact Windows & Doors Estimate in Lomita
Call (888) 345-8164 and a live person answers, day or night. We’ll set a time to walk your home, measure every opening, and hand you a written line-item estimate with the permit and installation detail spelled out. No pressure, no vague numbers. Financing at 0% for 18 months is available, and projects over $10,000 get $1,000 off.
Written by the team at Groundwork Construction Co.












