







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Lynwood, CA: What It Costs and How Long It Takes
A chain link fence in Lynwood typically runs $3,500 – $9,000 for a standard residential lot, and installation takes 2 to 4 working days from layout to final tensioning. Most of that cost is footage, height, and gate count, not the mesh itself. The 1920s – 1960s lots in the 90262 ZIP often change the number because of what’s already buried along the property line. Call (888) 345-8164 for a free on-site measure and a written line-item quote.
How We Build a Chain Link Fence in Lynwood, Stage by Stage

Stage 1: Site walk and layout (half a day). We walk the property line with you, note where the fence should run, and confirm where the gates land. You decide right here whether to keep any existing posts and whether the run stops at the garage or goes behind it. On Lynwood lots with a detached garage, that rear line is usually the decision that saves or adds money. We also check for sprinkler lines, irrigation valves, and the concrete or gravel strips already along the line before any digging starts.
Stage 2: Utility check and line location (before day 1 is over). We call in the 811 locate so gas, electric, and water are marked. On older Lynwood properties this matters more than people expect. A few decades of unpermitted additions and past remodels mean private lines sometimes run where the public maps don’t show them. Better to find that out on a walk than at the bottom of a post hole.
Stage 3: Removal and prep (day 1). Old fencing, posts, and concrete footings come out. Wood posts and rusted galvanized come up cleanly; set-in-concrete posts get broken out and hauled. Corner cleanup often runs longer than the first-time buyer expects, especially where a previous fence was built long and never re-tensioned. You’ll see a clear, stripped property line by the end of day 1.
Stage 4: Posts, framework, and mesh (days 2 – 3). We set terminal posts in concrete in the corners, ends, and gate posts, then top rail and line posts. The concrete cures overnight before the mesh gets pulled. On day 3 we stretch the fabric, cut to height, and attach with tension bands and ties. Gates get their frames and hinges and we check swing clearance. You decide at this stage whether you want a walk gate at both the driveway and the rear line or just one.
Stage 5: Hardware, tensioning, and walkthrough (day 4). We tighten everything, install latches, and check for gaps at the bottom. Then we walk it with you. Your footing depth, gate count, and any slope along the run are the details you’ll review then. If a run crosses a slope, expect a few extra line posts and about half a day.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Chain Link Options You’ll Actually Choose Between
The mesh itself is cheap. The pieces around it are where you decide what you’re getting. Most buying decisions come down to four choices.
- Height: 4 ft vs. 6 ft vs. 7 ft. A 4 ft fence is the cheapest per foot and fine for property marking. Six feet gives you real barrier, a bit more privacy, and is the standard residential height for a back yard. Going to 7 ft costs more in posts and concrete because the wind load climbs. Worth it only if you’re keeping a dog that can clear a 6 ft run.
- Galvanized vs. vinyl-coated mesh. Bare galvanized is the lowest-cost option in Lynwood, and it holds up well in the LA Basin’s dry heat. Vinyl-coated (black or green) looks cleaner against stucco and hedges. It costs more up front and the coating can chip at cut wire ends, but for a front-line fence most homeowners pick it for the look.
- Mesh gauge and wire thickness. A lighter gauge costs less and dents more. A heavier gauge is stiffer, holds its shape against a gate swinging into it, and outlasts the cheaper roll. For a back-line fence that just needs to mark a boundary, lighter is fine. For gates and high-traffic runs, pay for the heavier mesh.
- Gates: walk gate vs. double drive gate. A walk gate runs about a third of the price of a double drive gate. Adding a rear pedestrian gate to a detached garage setup is common. Drive gates need heavier posts set deeper because the weight swings on the frame, so plan them into the layout from the start rather than adding them later.
- Top rail and tension wire. A top rail stiffens the whole run. A bottom tension wire keeps the fabric from lifting and looks a little tidier. On a slope, tension wire is almost always the better choice because the mesh follows the grade without a rail line showing the rise.
What a Chain Link Fence Costs in Lynwood, CA

Plan on $3,500 – $9,000 for a standard residential chain link fence in Lynwood, with a typical 100-ft back-line install landing in the lower half of that range. A driveway-to-garage run with a drive gate and a walk gate lands near the top. Five variables move the number more than anything else:
- Linear footage. Every extra 10 ft of fence adds roughly 5 – 8% to the job. Most Lynwood lots in the 90262 ZIP are 5,000 – 6,000 sq ft, so a full perimeter is a real number.
- Existing fencing and concrete. Old posts set in concrete add removal and haul-away time. A stripped run drops the job toward the low end. Fence built over a concrete strip or asphalt requires breaking out for footing, which adds labor.
- Height and gate count. Taller fence means deeper posts, more concrete, more material. Each additional gate adds frame, hinge, latch, and its own footing.
- Slope and obstructions. A flat run is clean; sloped lines need extra line posts and stepping. Trees, retaining walls, and the rear of a detached garage all add a decision point.
- Vinyl coating and heavier mesh. These push the job toward the high end. Bare galvanized and a lighter gauge keep it low.
Our written estimate breaks out footage, posts, concrete, gates, and removal as separate lines. It’s upfront pricing, no surprises: the number you see is the number you pay. What we don’t include unless we tell you up front: old fence disposal where heavy material is present, and repairing lawn or gravel disturbed during post setting. Both are quoted separately so nothing shows up as a surprise on the invoice.
See the difference
Before
After
Before
After
Before
AfterWhat Lynwood Homes Specifically Do to This Chain Link Fence Job
Lynwood is a densely built, working-class city of one-story stucco houses on small lots. Most of the housing here went up between the 1920s and 1960s, and a lot of it has a detached garage in the back, sometimes converted to living quarters without permits. That matters for fences because the rear property line is often the most contested piece of the yard. When we run a chain link fence along the back line, we’re frequently working around a garage that was originally built as a shed, then became a room, then became a unit. So the fence either tucks behind the garage or dies into the corner of it. Both change the layout and the footage. On the north-south streets off Long Beach Blvd, the rear set-back is often short and the garage close to the property line, so a corner post placement needs careful measurement before we dig.
The LA Basin climate is kind to chain link. Mild, wet winters and hot, dry summers mean the fence won’t rot and won’t freeze into the ground. Winter rain does expose bare, uncoated galvanized over time, which is why vinyl-coated mesh holds up better here. If a fence is up against a low-slope patio cover or the rear of a garage, splashback from a winter rainstorm can shorten its life. The bigger local issue is the patchwork history of these lots. We routinely find old concrete strips, buried irrigation stubs from past additions, and fence lines built long and slack. None of that is a stop, but it’s the reason a written site walk before quoting beats a phone estimate every time.
Pairing the new fence with a clean driveway apron makes a real difference on these lots, and most homeowners we work with choose to do that at the same time. If you’re re-doing the front, homeowners often pair this with Concrete Driveways & Concrete Work in Lynwood and Asphalt Driveways & Resurfacing in Lynwood to get the fence footing and the driveway finished in one pass. If the fence is really part of a larger backyard plan, look at Fence Installation in Lynwood for the full scope, or see our fence installation service hub. We cover all of Lynwood, from Long Beach Blvd to the streets backing onto the 105.
Serving Lynwood, CA – Our Local Coverage Area
We serve Lynwood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Lynwood

A standard residential chain link fence in Lynwood takes 2 to 4 working days, with a 100-ft back-line run landing at the lower end and a full perimeter with two gates at the upper end. Removing old concrete-set posts and stepping a sloped line add roughly a day. Call (888) 345-8164 to schedule a free measure; we’ll give you a real date, not a range.
Most residential chain link fences in Lynwood don’t require a permit if they stay within the standard height limit for a residential lot. Anything taller than the limit, or a fence that runs in a required front setback, will need a check with the city before we install. We walk that with you during the free estimate so the height and location are settled first. Call (888) 345-8164 and we’ll tell you exactly what applies to your lot.
Yes, in most Lynwood backyard installs we work around the existing garage and utilities without touching either. We call 811 to mark public lines before digging and set posts around the garage corner, sprinkler runs, and any concrete already on the line. If a rear addition or converted garage blocks the natural line, we route the fence to a clean corner post instead. Call (888) 345-8164 and we’ll walk the yard to confirm it’s a clean run.
Installed chain link fence in Lynwood runs about $35 – $90 per linear foot depending on height, mesh gauge, coating, and gate count. A 100-ft bare galvanized run with no gates sits near the low end of that per-foot range. Vinyl coating, heavier mesh, a drive gate, and slope all move it toward the top. Call (888) 345-8164 for a written line-item quote; estimates are free.
Every chain link fence we install is covered by our 730-Day Done Right Promise, which means if it’s not done right, we make it right. That covers post setting, tensioning, hardware, and gate alignment for two full years after install. It’s one of the longest workmanship guarantees in the residential construction space. Call (888) 345-8164 to book your free estimate and get the promise in writing.
Free On-Site Estimate for a Chain Link Fence in Lynwood
Call (888) 345-8164 to book a free on-site estimate for your chain link fence in Lynwood. A live person answers, day or night. We’ll measure the property line, settle the height and gate placement, and give you a written line-item quote before any work starts. Our technicians have up to 12 years of experience with residential fencing. No deposit is required for the estimate.
Written by the team at Groundwork Construction Co.












