







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vanities, Tile & Fixtures in Lynwood, CA: What It Costs and How Long It Takes
Replacing a bathroom vanity and re-tiling the floor and tub surround in Lynwood usually runs $9,000 – $28,000 when it’s part of a broader bathroom refresh, and a straightforward vanity-plus-tile swap with fixtures often lands between $3,400 and $9,000. Most of these jobs take five to nine working days from demo to final caulk. Call (888) 345-8164 and we’ll walk your Lynwood bathroom room-by-room and put a written number in front of you.
How We Sequence Vanities, Tile & Fixtures Work, Day by Day

Bathrooms punish anyone who rushes the order of operations. Here’s the actual sequence we run on a Lynwood vanity, tile, and fixture job, with what you’ll be deciding at each stage.
Stage 1: Demo and substrate inspection (1 – 2 days)
We pull the old vanity, toilet, and fixtures and take up the floor tile. Then the wall comes open. On a 1950s Lynwood house, this is where we find out whether the previous layer was set over drywall or green board, whether the tub surround has rot behind the tile, and whether the shutoff valves are the original gate valves. You’ll get a call that same day if anything behind the wall changes the scope.
Stage 2: Rough-in adjustments and framing (1 day, or 2 – 3 if plumbing moves)
Moving the vanity drain or supply lines across the room means cutting the slab or opening the wall, so that’s a decision to make before demo, not after. Same with adding a GFCI outlet or a second sink. We set the valve heights, install a new waterproofing layer, and square the framing so the tile lays flat.
Stage 3: Tile set and cure (2 – 3 days)
Floor tile goes down first so the vanity can sit on top of it. We let thin-set cure overnight before grouting. Large-format 24×48 tile is one of the most requested upgrades we install. You choose grout color and whether you want the floor and walls to match; expect 24 hours of dry time before anyone walks on it.
Stage 4: Vanity, top, and fixtures (1 – 2 days)
Vanity cabinet gets set and shimmed level, then the countertop, the sink, the faucet, and the mirror and light bar. We pressure-test every supply connection and run the drain before the water goes back on. Anything Kohler-spec gets installed to the manufacturer’s clearances.
Stage 5: Final finish and inspection (1 day)
We silicone the wet seams, reinstall the toilet with a fresh wax ring, hang the accessories, and clean the room. If the job pulled a permit, we schedule the final inspection and walk it with you afterward. That’s the last day the room is off-limits.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between on Vanities, Tile & Fixtures
A vanity is part cabinet, part countertop, and part fixtures, and each of those three purchases does something different to your budget. Here’s the honest trade-off on each choice we help Lynwood homeowners make.
- Vanity cabinet – stock vs. semi-custom vs. custom. Stock sizes (24″, 30″, 36″, 48″) arrive fast and cost the least, but they only fit where the wall allows. Semi-custom lets you pick door style and finish within a day or two; custom is built to the inch but adds two to four weeks. KraftMaid sits in the semi-custom range and gives you real finish choices without a custom lead time.
- Countertop – quartz vs. porcelain vs. granite. Quartz handles moisture and daily cleaning without sealing and holds up best over the long haul. Porcelain slab is thinner and lighter and gives a near-seamless look at a lower price. Granite is durable, but it’s porous and needs periodic sealing.
- Floor tile – porcelain vs. ceramic vs. natural stone. Porcelain is denser and takes a wet environment better than ceramic. Ceramic costs less and is fine for a low-traffic hall bath. Natural stone looks best but needs sealing every year or two.
- Shower wall tile – large format vs. mosaic. Large-format means fewer grout lines to scrub and a cleaner look. Mosaic is easier to slope on the shower floor and can read more traditional. Grout line spacing drives both the look and the cleaning effort.
- Faucets and trim. A basic chrome faucet costs a fraction of a brushed-brass or matte-black Kohler fixture. The finish choice is mostly aesthetic; the valve body behind it is what determines reliability.
What Vanities, Tile & Fixtures Costs in Lynwood, CA

Vanity, tile, and fixture work in Lynwood runs $9,000 – $28,000 when it’s part of a full bathroom refresh, or $3,400 – $9,000 for a vanity and tile-and-fixtures swap in an existing footprint. Here’s what moves a job toward the low or high end:
| Line item | Typical range |
|---|---|
| Bathroom Vanity Installation | $800 – $3,000 |
| Full bathroom remodel (vanity + tile + fixtures) | $9,000 – $28,000 |
| Small bathroom remodel | $5,000 – $12,000 |
| Shower replacement | $3,000 – $8,500 |
What pushes a number up: relocating the drain or water lines, opening a wall to add an outlet or a second sink, replacing a rotten tub surround substrate, and a tile upgrade to large-format porcelain or natural stone. What pulls it toward the low end: keeping the vanity and fixtures where they are, choosing stock cabinetry, and staying with standard-size floor tile. A written, line-item estimate includes demo, haul-away, material, and labor with no change-orders unless the scope itself changes. Permit fees are quoted separately from labor. Call (888) 345-8164 for an exact quote on your Lynwood bathroom.
See the difference
Before
After
Before
After
Before
AfterWhat Lynwood Homes Specifically Do to This Job
Most of the Lynwood bathrooms we open up are inside one-story 1920s – 1960s stucco-over-wood-frame houses on 5,000 – 6,000 square foot lots in the 90262 ZIP. That build era means we routinely find patchwork framing and older two-wire circuits when the vanity wall comes open, and sometimes aluminum wiring in the 1960s builds. Any of those adds a day and a decision before tile goes back up. Because so much of this housing has a history of unpermitted additions, we check the permit record before we demo; if the bathroom or a prior garage conversion shows up as converted living space with no paperwork on file, that paperwork has to be resolved or the room has to be legalized before we start. We work alongside trusted partners on the roof side too, and homeowners often pair this with Tile Roofing in Lynwood or Specialty Roofing in Lynwood when the wet winter season has exposed a leak above the ceiling. Tile work in Lynwood is year-round since the region is mild, but the hot, dry summers mean setting tile on a hot slab needs extra care on the cure. If the bathroom refresh is part of a bigger update, this scope folds naturally into Bathroom Remodeling in Lynwood, and this page is one part of our Bathroom Remodeling work across the area. We cover all of Lynwood and the surrounding neighborhoods.
Serving Lynwood, CA – Our Local Coverage Area
We serve Lynwood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Vanities, Tile & Fixtures in Lynwood

A vanity-plus-tile swap usually takes five to seven working days; add two to three days if plumbing, electrical, or framing has to move. The clock starts on demo day and stops at the final inspection. Call (888) 345-8164 to schedule a free on-site estimate and we’ll give you a dated schedule.
Cosmetic tile and a vanity swap usually don’t require a permit, but relocating plumbing, adding a new circuit, or replacing a tub within a shower does. We pull what’s required and schedule the inspection so the final walk-through paperwork is in your hands. Permit fees are quoted separately in your estimate.
Yes. A standard-size stock or semi-custom vanity will set right over the existing supply and drain lines if the rough-in is centered. If you want the vanity moved even six inches, the drain has to move with it, which means opening the wall or the slab. We tell you which situation you’re in before demo day, not after.
The lead range for this job is $9,000 – $28,000 for a broader bathroom refresh, or $3,400 – $9,000 for a vanity and tile-and-fixtures swap. A vanity installation alone lands around $800 – $3,000. Call (888) 345-8164 for a written line-item quote; estimates are free.
Workmanship on every project is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. Product warranties pass through from the manufacturer on fixtures and tile, so you keep the paperwork. Call (888) 345-8164 to walk through your Lynwood scope with a live person.
Get a Free Estimate for Vanities, Tile & Fixtures in Lynwood
We’ll come out, walk the bathroom, measure the vanity wall, and talk through the tile and fixture choices before you commit to anything. You’ll leave the visit with an upfront, line-item written estimate – and our 730-Day Done Right Promise backing the workmanship. Call (888) 345-8164 to schedule your free estimate, day or night; a live person always answers.
Written by the team at Groundwork Construction Co.












