







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Small & Partial Kitchen Remodels in Lomita, CA: What They Cost and How Long They Take
Small & partial kitchen remodels in Lomita typically run $14,000 – $45,000 and take three to five weeks when the layout stays put. If you’re keeping the sink, range and fridge where they are and updating the worn surfaces around them, most of our Lomita projects land closer to $18,000 – $26,000. Call (888) 345-8164 for a free on-site estimate with a written line-item number.
This page is about the partial job specifically: new cabinet fronts or boxes, countertop, backsplash, lighting and a repaint rather than a full gut. If your project reaches into walls, moves a window, or opens a doorway, that’s a different scope and it lives on our Kitchen Remodeling in Lomita page.
How a partial kitchen job actually runs, stage by stage

Nobody can tell you day one vs day three from a photo, so here’s the sequence we follow on a partial remodel where plumbing and gas stay in place.
Stage 1: measure, verify, lock the schedule (days 1 – 2)
We photograph and measure every wall, check that the existing shutoffs and outlets are actually where the last owner thought they were, and confirm the countertop template date. You decide two things here: the cabinet door style and the countertop material. Both affect lead time, and that’s what sets the calendar.
Stage 2: protect, demo, prep (days 3 – 5)
Floors and adjoining rooms get covered, appliances are pulled and stored, and old counters, backsplash and cabinet doors come out. We open a small inspection hatch if the electrical or plumbing situation is unclear. In older Lomita bungalows this is where we find out whether the wall behind the tile is drywall or the original plaster-and-lath, and that discovery is the single most common reason a partial job gets re-quoted.
Stage 3: rough-in corrections and cabinets (days 6 – 12)
Any outlet, valve or drain that fails inspection gets corrected before new material covers it. Then cabinet boxes go in and get shimmed, leveled and screwed to studs. You approve door and drawer placement before fronts go on. If you’re choosing between KraftMaid and a semi-custom line, this is the stage where the difference in lead time actually bites.
Stage 4: template, counters, backsplash (days 12 – 20)
Countertop templating happens after cabinets are set, never before. Quartz or granite fabrication usually takes 5 – 10 business days, then install is a single visit. Backsplash goes in after the counter is seated so the cuts line up. You pick grout color and edge profile here, which is a small decision that changes how the whole kitchen reads.
Stage 5: finish, punch, final walk (days 20 – 45)
Reconnect the sink and disposal, hang doors and hardware, touch up paint, and test every outlet and light. We walk the room with you against the written scope, and anything that doesn’t match gets fixed before we consider the job closed. That’s what the 730-Day Done Right Promise covers: if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The choices that shape a partial kitchen job in Lomita
Most of the money in a partial remodel sits in four decisions. Here’s the honest trade-off on each.
- Cabinet fronts vs. full boxes. Refacing existing boxes runs roughly 40% less than new cabinets and keeps your layout intact, but it only works if the boxes are square and the hinges aren’t blown out. In a 1950s Lomita home, the boxes are often fine and the doors are the problem, which makes refacing a genuinely good call.
- Quartz vs. granite vs. butcher block. Quartz is uniform, non-porous and forgiving on a busy counter. Granite is harder to match across slabs and needs sealing. Butcher block is warm and cheaper up front but wants oiling. For a partial job where the counter is the visual anchor, quartz is usually the cleanest answer.
- Backsplash tile. A ceramic subway tile is the budget winner and easy to keep clean. A full-height slab backsplash costs several times more but eliminates grout lines entirely. Most Lomita homeowners land on ceramic or porcelain, full height only behind the range.
- Sink and faucet. Keeping the sink saves money but forces the counter cutout to match the old basin. A new undermount sink and faucet is a modest upgrade that makes a partial job look finished rather than patched.
- Lighting. Recessed cans are the default, but under-cabinet LED strip is the cheapest way to make a small kitchen feel larger and lighter. It’s also the upgrade people notice most.
Our Kitchen Remodeling service covers the wider material catalog if you want to go beyond these four.
What Small & Partial Kitchen Remodels cost in Lomita, CA

The lead range is $14,000 – $45,000. Where you land inside that band depends on five variables, and the low end is a real number, not a teaser.
| Line item | Typical range |
|---|---|
| Cabinet installation or refacing | $4,000 – $13,000 |
| Countertop installation | $2,000 – $6,500 |
| Backsplash installation | $800 – $2,500 |
| Small kitchen remodel (full scope) | $9,000 – $20,000 |
| Partial remodel total | $14,000 – $45,000 |
What pushes a job toward the top of the range: relocating the sink or range (plumbing and gas work plus inspection), opening a wall or doorway (structural and possibly a beam), correcting knob-and-tube or galvanized lines, upgrading to a full slab backsplash, and a permit scope that goes past cosmetic. What keeps it low: keeping the layout, refacing instead of replacing boxes, a ceramic backsplash, and no electrical relocations.
A written estimate from us lists demo, cabinets, counter, backsplash, labor, permits where required, and haul-away. It does not include appliance purchases, structural engineering if a wall comes down, or anything you add mid-job. Those get quoted in writing before we touch them. The number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Lomita homes specifically do to this job
Lomita is about a square mile, fully built out, and surrounded by Torrance, so almost every project here is a remodel on a tight infill lot rather than anything new. The housing stock we work in most is 1920s – 1950s wood-frame bungalows and early tract homes on 5,000 – 6,000 sq ft lots, and that age shows up directly in a partial kitchen job. We regularly open a wall near the Pacific Coast Highway corridor and find galvanized supply lines, two-wire outlets with no ground, and plaster over wood lath instead of drywall.
Permitting is the other local reality. Because Lomita runs its own small-city building department rather than sitting inside a larger county process, plan check is handled locally and reviewed lot by lot. A cosmetic partial (paint, cabinet fronts, counter swap) typically doesn’t need a permit. Anything that touches electrical circuits, plumbing lines or structure does. We pull the permits and take the inspections, and we’ll tell you up front which side of that line your job falls on.
The marine layer and salt air are a quieter factor. They don’t hurt a kitchen directly, but they do the same number on the envelope that they do everywhere else in this city, and a kitchen wall shared with a bathroom or exterior is where we find the rot. If the inspection turns up water damage, homeowners often pair this with Roof Repair in Lomita or, when the adjoining half-bath is also tired, Small Bathroom Remodels in Lomita. We cover the whole city, and you can see the full area on our Lomita service page.
Serving Lomita, CA – Our Local Coverage Area
We serve Lomita and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Small & Partial Kitchen Remodels in Lomita

Three to five weeks from demo to final walk for a typical partial job, with countertop fabrication being the longest single wait at 5 – 10 business days. Cabinet lead time and any permit inspection can stretch it. Call (888) 345-8164 for a schedule estimate tied to your actual scope.
Not for paint, cabinet fronts, counters or a backsplash. You do for electrical circuit changes, plumbing relocation or anything structural, and the City of Lomita’s building department reviews those locally. We handle the permit and the inspection, and we’ll flag it before work starts.
Yes, and that’s the whole point of a partial job. Keeping the sink, range and walls where they are is what keeps the number near $18,000 – $26,000 instead of the $45,000 top of the range. Moving any of them turns it into a different scope.
Most partial jobs land between $14,000 and $45,000, with refacing and a ceramic backsplash at the low end and relocated plumbing or a wall opening at the high end. Call (888) 345-8164 for an exact quote. Estimates are free and line-itemed.
Every project is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in residential construction, and it applies to labor and installation, not manufacturer defects, which carry their own coverage.
Get a free estimate for your Lomita partial kitchen
Call (888) 345-8164 to schedule a free on-site estimate. We’ll measure the room, confirm whether your job stays cosmetic or needs a permit, and hand you a written line-item quote with no change-order surprises. Calls are answered by a live person, 24/7. Background-checked, uniformed technicians on every visit. Projects over $10,000 get $1,000 off, and 0% financing for 18 months is available if you want to spread the cost.
Written by the team at Groundwork Construction Co.












