







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Metal Roofing in South Gate, CA: What It Costs and How Long It Takes
Metal roofing in South Gate runs $15,000 – $40,000 for a typical single-family home, with most jobs landing in the $18,000 – $28,000 range for a straight replacement over existing 1920s – 1960s tract housing. Plan on two to four days for tear-off and install on a 1,200 – 1,600 sq ft roof, plus a week or two for the permit review through the city. Call (888) 345-8164 and we’ll walk the roof, measure the squares, and put a line-item number in front of you.
How we actually put a metal roof on a South Gate house

Metal isn’t a “show up and screw down panels” job. The order matters, and skipping a stage is how roofs leak within five years.
Day 1 morning: tear-off and deck inspection
The crew strips the old shingles or torch-down to bare sheathing, then walks the deck board by board. On these older South Gate homes, we’re looking for soft spots, popped nails, and the rot that hides under a 40-year-old layer. Any bad sheathing gets replaced before we go further. You decide at this point whether to add cost for deck repair or cap it and accept the risk. We don’t recommend capping.
Day 1 afternoon: underlayment and ice-and-water
We roll synthetic underlayment across the whole deck and run peel-and-stick membrane in the valleys and at every penetration. This is the layer nobody sees and the one that fails first if it’s done cheap. Two to three hours on a standard house.
Day 2: trim, eave, and edge metal
Drip edge, rake trim, and eave closures go on before any panel. On a metal roof, the trim is structural, not decorative; it’s what keeps wind-driven rain from getting under the sheets. Half a day.
Day 2 – 3: panel installation
Panels go down in runs, screwed at the correct clip spacing per the manufacturer’s spec. We follow the exact fastening pattern for the panel profile you chose. Rushing this stage causes oil-canning and warranty denials. This is the stage you’ll notice the most if the crew knows what they’re doing.
Day 3 – 4: ridge, flashing, and final inspection
Ridge cap, vent flashing, chimney and skylight boots, then a full water test and a walk-through with you. We pull the permit and coordinate the city inspection as part of the job. If the inspection flags anything (and in South Gate, older homes sometimes get flagged for unrelated prior work), we handle it and fix it before we call the job done.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The metal roofing choices that actually matter
- Standing seam vs. exposed-fastener panels. Standing seam costs more ($18,000 – $30,000 for a typical South Gate house) but hides the fasteners and holds up for 40+ years. Exposed-fastener panels run $15,000 – $22,000 and are fine on a garage or a simple gable, but the washers age out sooner and need periodic checks.
- 26-gauge vs. 24-gauge steel. 24-gauge is heavier, holds up better against hail and denting, and costs roughly 10 – 15% more. For most South Gate homes, 26-gauge is plenty; if you’re on a corner lot with a lot of foot traffic or tree overhang, go heavier.
- Kynar 500 finish vs. standard polyester. Kynar holds color for decades; standard polyester fades within 10 – 15 years. The premium is small compared to replacing the roof again, so we default to Kynar on the panels you’ll actually see.
- Panel profile. A 1-inch rib standing seam reads clean and modern; a 1.5-inch rib reads taller and more traditional. Both work on these houses; it’s a looks call, not a performance one.
- Color. Lighter colors (bone, ash gray, light bronze) reflect more heat, which matters on hot LA basin summers. Darker charcoal and forest green look great but run hotter under the deck.
- Concealed vs. exposed gutter. If you’re pairing this with new gutters, decide now. Retrofitting gutter hangers after the roof goes on is more expensive than doing both at once.
What Metal Roofing costs in South Gate, CA

Full metal roof replacement here lands between $15,000 and $40,000. The variables that push you toward the low or high end are concrete, not vague:
- Roof size and pitch. A 1,200 sq ft low-slope roof on a small South Gate lot is at the bottom of the range; a 2,000 sq ft steep-pitch house is at the top. Steep pitch slows the crew and requires more safety rigging.
- Deck condition. On pre-1960 housing stock, we frequently find soft sheathing and dry rot at the eaves. Replacing 10 – 20% of the deck adds $1,500 – $4,000.
- Panel type. Exposed-fastener vs. standing seam moves the total by $4,000 – $8,000.
- Complexity. Valleys, dormers, skylights, and multiple roof planes add labor. A simple gable is fast; a hip-and-valley with two chimneys is not.
- Permit scope. A full re-roof permit is cleaner than a repair-over, and South Gate is strict on tear-off and inspection. Budget for it in the number; don’t let anyone quote you a price that skips it.
Our written estimate breaks every line item: deck repair (if any), material, labor, permit, disposal, and trim. There’s no “allowance” line that gets quietly bumped after the job starts. The number you see is the number you pay. We also offer 0% financing for 18 months and $1,000 off projects over $10,000.
See the difference
Before
After
Before
After
Before
AfterWhy these South Gate neighborhoods make this job different
Most of the metal roofs we install in South Gate are on the same housing stock: modest single-family homes built between roughly 1920 and 1960, with detached garages and shallow front setbacks. That matters. These are tight lots, so dumpsters and material staging can be a real headache; a lot of crews wind up parking on the street, and South Gate is strict about parking. The city also has a lot of homes with unpermitted additions from decades past; we check for those on the front end because they can trigger complications at the inspection. If your roof replacement is part of a full Roofing in South Gate scope, or if you’re coordinating it with Window Replacement in South Gate or Impact Windows & Doors in South Gate, we sequence the trades so the roof goes on before the windows go in. The expansive clay soils here don’t affect the roof deck directly, but they do mean the foundation and structural tie-ins deserve a look while we’re up there. That’s our Roofing service in the broader sense, and it’s why we work all over South Gate rather than treating it as a pass-through.
Serving South Gate, CA – Our Local Coverage Area
We serve South Gate and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Metal Roofing in South Gate

Two to four days on the roof, plus roughly one to two weeks for permit review and inspection. Most of that gap is city processing, not our schedule. Call (888) 345-8164 and we’ll give you a specific timeline for your address.
Yes. A full re-roof requires a permit through the city, and the inspection process will verify both the tear-off and the installation. We pull the permit and manage the inspection; you don’t have to walk anything through the counter yourself.
Almost always, yes. Metal roofing is a roof-only job unless we uncover rot in the sheathing or damage at a penetration. We flag any structural issue to you before doing anything beyond the quoted scope.
Between $15,000 and $40,000 depending on roof size, pitch, panel type, and deck condition. A straightforward 1,400 sq ft gable with decent deck typically lands around $22,000. Call (888) 345-8164 for an exact line-item quote; estimates are free.
Our work is covered by the 730-Day Done Right Promise; if it’s not done right, we make it right. Panel finish warranties come from the manufacturer, and we hand you the paperwork at the end. No fine print surprises.
Get a free metal roofing estimate in South Gate
Call (888) 345-8164 and a live person answers, day or night. We’ll set up a free on-site visit, measure the roof, check the deck, and hand you a written line-item estimate. The number you see is the number you pay, backed by the 730-Day Done Right Promise. Trees, chimneys, and old South Gate stucco don’t scare us.
Written by the team at Groundwork Construction Co.












