







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vanities, Tile & Fixtures in Carson: What the Job Costs and How Long It Takes
Vanities, tile and fixtures in Carson, CA usually run $9,000 – $28,000 for a full tear-out and rebuild, and a typical job runs 2 – 3 weeks on site once materials are in hand. A vanity-only swap lands at $800 – $3,000; tiling a tub surround or shower walls sits inside the wider range. Most Carson bathrooms we open were built between the 1950s and 1970s, so what’s behind the old tile decides the schedule. Call (888) 345-8164 for a free on-site estimate.
How we run Vanities, Tile & Fixtures work, stage by stage

Stage 1 – Tear-out and inspection (day 1 – 2). We pull the old vanity, toilet and tile down to the studs and subfloor. This is the day the job tells the truth: in Carson’s 90745 and 90746 tract homes we routinely find dry-set mortar over wire lath, or tile set directly on greenboard that’s swollen from a slow supply-line drip. You’ll decide right here whether the subfloor gets patched or replaced, because tile that goes down over a soft floor cracks at the grout lines within a year.
Stage 2 – Rough plumbing and electrical (day 2 – 3). If the vanity is moving, or a wall sconce is shifting, this is when it happens. Vanity relocations on a slab mean trenching the floor; on older raised sections there’s usually a crawl space to work in. You’ll choose the vanity width and sink layout before we cut, since a 60-inch double moves the drain and supply lines differently than a 36-inch single.
Stage 3 – Backer board and waterproofing (day 3 – 4). Cement backer board goes up wet areas, seams get taped and floated, and a liquid-applied or sheet membrane seals the shower pan and walls. We hold for a cure before tile, which is the one stage we don’t compress. Skipping it is the most common reason a shower leaks a year later.
Stage 4 – Tile set and grout (day 5 – 9). Wall tile and floor tile get set, then grout after a full cure. You’ll pick layout now if you haven’t: running bond, stacked, or large-format with a small joint. A 12×24 porcelain floor goes faster than a herringbone mosaic and costs less in labor for the same square footage.
Stage 5 – Fixtures, vanity, trim and inspection (day 10 – 14). Vanity and top set, faucet and drain connected, toilet reset, mirror and lighting hung, caulk lines run. If the job pulled a permit, the city inspection closes it out. You walk the room with us before we call it finished.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll weigh before tile goes down
These are the choices that move both the look and the budget. We walk through samples with you because a 3-inch chip looks a lot different than a full bathroom wall.
- Vanity: stock, semi-custom, or custom. Stock cabinets in 30 – 48 inch widths are the cheapest and ship fastest. Semi-custom lets you set depth and door style, usually a better fit for older Carson bathrooms with odd wall lengths. Custom matches a specific footprint but adds weeks and cost.
- Vanity top: quartz, granite, or cultured marble. Quartz is the durable all-rounder with low maintenance. Granite gives natural variation but needs sealing. Cultured marble is the budget option; it scratches and shows wear sooner.
- Floor tile: porcelain vs. ceramic vs. natural stone. Porcelain holds up best to moisture and foot traffic. Ceramic is cheaper and fine on walls. Natural stone (travertine, slate) looks great but needs sealing and loves to stain in a wet room.
- Wall tile size. Large-format 12×24 and 24×48 porcelain covers more wall with fewer grout lines and less labor. Subway and mosaic patterns cost more in time and grout upkeep.
- Fixtures: finishes and brands. Kohler and similar lines give dependable cartridges and finishes; brushed nickel and matte black show water spots differently than chrome. Budget brand-name faucets over no-name ones that fail at the cartridge in two years.
- Waterproofing system. A bonded sheet membrane or a liquid-applied system both work when installed correctly. This isn’t a place to save money; it’s the difference between a tight shower and a repair.
What Vanities, Tile & Fixtures costs in Carson, CA

Expect $9,000 – $28,000 for a full vanities, tile and fixtures job in Carson. Here’s the line-item breakdown we use in written estimates:
| Line item | Typical range |
|---|---|
| Vanity and top installation | $800 – $3,000 |
| Floor and wall tile (materials + labor) | $3,000 – $10,000 |
| Fixtures: faucet, shower trim, toilet | $1,200 – $4,500 |
| Waterproofing and backer board | $800 – $2,500 |
| Rough plumbing and electrical (if relocating) | $1,500 – $6,000 |
| Permit and inspection | $300 – $1,200 |
What pushes the number up: relocating plumbing or electrical, replacing a soft subfloor, large-format or natural stone tile, custom vanity millwork, and permit scope when the layout changes. A straight swap in the same footprint with stock materials sits near the low end; a full rebuild with a moved vanity, custom cabinetry and stone stays near $28,000.
Every Groundwork estimate is written line by line with the number you pay. No change-order surprises mid-job. Our ongoing promotions take some off the top: $1,000 off projects over $10,000, and 0% financing for 18 months. Call (888) 345-8164 for an exact quote.
See the difference
Before
After
Before
After
Before
AfterWhat Carson homes specifically do to this job
Carson is a master-planned mid-century suburb, laid out mostly in the 1960s and 1970s over former Rancho San Pedro and Dominguez land, so nearly every vanities, tile and fixtures job here is a code-upgrade on aging tract housing rather than new construction. Bathrooms in the 90745 and 90746 ZIPs routinely turn up original single-handle valves, cast-iron drains, and galvanized supply lines. Because the city grew on the back of an oil-field legacy, any work that reaches below slab or moves a wall runs up against permit review that neighboring cities rarely require, so we plan footing and drain decisions early in the estimate rather than mid-job. The marine layer and salt air off the South Bay accelerate corrosion on cast-iron and metal trim, which is why we spec replacement drains where we find pitting instead of sealing over them. Homeowners often pair this tile and fixture work with exterior projects, like Tile Roofing in Carson or Specialty Roofing in Carson, while the crews are already on site.
We cover the whole city, from the tract blocks near Cal State Dominguez Hills to the streets off Avalon Boulevard and Carson Street, as part of our broader Carson service. For a wider scope, this often fits inside a full Bathroom Remodeling in Carson project, and our Bathroom Remodeling service line covers the plumbing, layout, and permit side.
Serving Carson, CA – Our Local Coverage Area
We serve Carson and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Vanities, Tile & Fixtures in Carson

Two to three weeks on site for a full bathroom, from tear-out to final inspection. Vanity-only swaps take a day or two. Ordering materials early matters: a custom vanity or a special-order tile can add 1 – 3 weeks of lead time before work starts.
A permit is usually required when you move plumbing, electrical, or walls. Cosmetic tile and a like-for-like vanity swap typically don’t trigger one. We pull the permit when the scope calls for it and pass the inspection before we hand you the keys.
Yes. Most vanities, tile and fixtures jobs stay inside the existing footprint, and you save on rough plumbing and permit costs. The subfloor and drain condition still get checked before tile goes down, since a soft subfloor under old tile is a risk even without a layout change.
Full projects run $9,000 – $28,000, with a standalone vanity installation at $800 – $3,000. Tile grade, custom cabinetry, and any plumbing relocation move the number most. Call (888) 345-8164 for an exact quote; estimates are free.
Every vanities, tile and fixtures job is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in residential construction, and it’s in writing on every contract.
Get a free estimate on Vanities, Tile & Fixtures in Carson
We’ll walk the bathroom with you, measure the walls and floor, and flag subfloor or plumbing issues before they become a surprise. You leave with a written line-item estimate and a realistic start date. Reach us at (888) 345-8164, and expect a live person on the line, day or night, ready to schedule your free on-site estimate.
Written by the team at Groundwork Construction Co. of Long Beach.












